Custom Molybdenum-Bearing 316L Stainless Strip
Modified 316L austenitic stainless steel cold-rolled strip with 3.8% molybdenum and 11% nickel, 240 mm width, 1.1 mm thickness. HTS 7220.20.70.10 applies to this not-further-worked stainless product within precise width, thickness, and alloy parameters.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If of a width of 300 mm but less than 600 mm
Same specs but 300-600 mm width range uses dedicated intermediate width subheading.
If alloy steel not qualifying as stainless
Less than 10.5% chromium content would classify as general alloy flat-rolled steel.
If of tool steel composition
If meeting tool steel element combinations in Chapter note (e), shifts to tool steel heading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify not heat-resisting steel per Chapter note (g)—requires <0.3%C, 4-10.5%Cr
• Provide dimensional inspection reports
• No duty reduction for pre-entry rust per Chapter note
Related Products under HTS 7220.20.70.10
17-4 PH Stainless Steel Cold-Rolled Strip
Cold-rolled flat-rolled stainless steel strip of 17-4 PH alloy (UNS S17400), width 250 mm, thickness 0.8 mm, containing ~4% molybdenum and ~4% nickel. Classified under HTS 7220.20.70.10 due to stainless steel composition, cold-rolled state, width <300 mm, thickness 0.25-1.25 mm, and specific Ni/Mo content ranges.
Custom 15-5 PH Stainless Steel Sheet
Cold-reduced stainless steel sheet of 15-5 PH precipitation hardening grade, 280 mm wide, 1.0 mm thick, with 3.2% Mo and 4.2% Ni. Fits HTS 7220.20.70.10 as flat-rolled stainless, not further worked than cold-rolled, specific dimensions and alloying elements.
Nitronic 50 Stainless Steel Cold-Rolled Band
Nitronic 50 (XM-19) austenitic stainless steel cold-rolled band, 150 mm width, 0.6 mm thickness, featuring 2.0% molybdenum and 12% nickel. Meets HTS 7220.20.70.10 criteria for stainless steel, cold-rolled, narrow width, intermediate thickness, and specified alloy limits.
PH 13-8 Mo Stainless Steel Precision Strip
Precision cold-rolled strip of PH 13-8 Mo martensitic precipitation hardening stainless steel, 200 mm wide, 0.9 mm thick, 2.5% Mo, 8.5% Ni. Classified in HTS 7220.20.70.10 for stainless flat-rolled products meeting exact dimensional and compositional requirements.
A286 Stainless Steel Cold-Reduced Ribbon
A286 precipitation hardening stainless steel cold-reduced narrow ribbon, 180 mm wide, 0.4 mm thick, 1.8% Mo, 15% Ni. Perfectly matches HTS 7220.20.70.10 for cold-rolled stainless steel of specified narrow width, thickness range, and intermediate Mo/Ni levels.
Alloy 904L Stainless Steel Cold-Rolled Foil Alternative
904L super-austenitic stainless steel cold-rolled strip (thicker variant), 290 mm width, 1.2 mm thick, 4.1% Mo, 25% Ni. HTS 7220.20.70.10 classification based on stainless nature, cold-reduction only, precise width/thickness, and qualifying Ni/Mo percentages.