Containing less than 15 percent by weight of chromium
Flat-rolled products of stainless steel, of a width of less than 600 mm: > Not further worked than cold-rolled (cold-reduced): > Of a width of less than 300 mm: > Of a thickness exceeding 1.25 mm > Other: > Other: > Containing less than 15 percent by weight of chromium
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7220.20.60.60
AISI 410 Cold-Rolled Stainless Steel Strip
Cold-rolled flat strip of AISI 410 martensitic stainless steel, width 250 mm, thickness 1.5 mm, containing 11.5% chromium by weight. This product is not further worked beyond cold-rolling and falls under HTS 7220.20.60.60 due to its narrow width under 300 mm, thickness over 1.25 mm, and chromium content below 15%. Used in cutlery and valve components.
13% Chromium Cold-Reduced Steel Sheet
Cold-reduced stainless steel sheet, 280 mm width, 2.0 mm thick, with 13% chromium content, suitable for automotive trim. Classified under HTS 7220.20.60.60 as a narrow (<300 mm), thick (>1.25 mm) cold-rolled product not further worked, distinguished by low chromium martensitic composition.
Martensitic 420 Stainless Steel Coil Strip
Narrow coil strip of AISI 420 stainless steel, 1.8 mm thick, 290 mm wide, 12.8% chromium, cold-rolled for pump shafts. HTS 7220.20.60.60 applies to this not-further-worked product due to width <300 mm, thickness >1.25 mm, and sub-15% chromium meeting legal definitions.
Low Chromium 410S Cold-Rolled Ribbon
Cold-rolled ribbon of 410S stainless steel (11% Cr), 1.6 mm thick, 150 mm wide for razor blade stock precursors. Fits HTS 7220.20.60.60 as cold-rolled, narrow flat-rolled stainless with thickness exceeding 1.25 mm and chromium under 15%, not further worked.
Cold-Reduced 12% Cr Valve Steel Sheet
Cold-reduced sheet of 12% chromium valve steel, 220 mm width, 1.75 mm thickness for engine valve production. This stainless steel product is classified in HTS 7220.20.60.60 for its cold-rolled state, narrow width, specified thickness, and chromium below 15% threshold.