Cold-Reduced 409 Stainless Steel Strip 0.8mm x 450mm
Cold-reduced flat-rolled product of grade 409 stainless steel with less than 15% chromium by weight, 0.8mm thick and 450mm wide, suitable for exhaust system components. Classified under HTS 7220.20.10.60 due to cold-rolling process only, width between 300-600mm, and low chromium composition as per U.S. note definitions. Ideal for ferritic stainless applications requiring good formability.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If of a width less than 300 mm
Tariff subheading explicitly splits at 300mm width within the same cold-rolled stainless category.
If not stainless steel alloy
Lacking sufficient chromium for stainless classification (typically <10.5% Cr), moves to non-stainless flat-rolled steel in 7219.
If supplied in coil form exceeding certain parameters
Coiled products may fall under heading 7225 for specific stainless steel configurations.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide chemical composition analysis from manufacturer confirming chromium below 15% threshold
• Label entries clearly as 'not further worked than cold-rolled' to prevent inspection reclassification
• Watch for coil vs. sheet declarations; statistical suffixes may vary but base classification remains
Related Products under HTS 7220.20.10.60
Cold-Rolled 430 Stainless Steel Sheet 1.0mm x 500mm
Flat-rolled stainless steel sheet made from grade 430 alloy containing approximately 16-18% chromium but certified under customs documentation as less than 15% effective chromium content for tariff purposes, cold-rolled to 1.0mm thickness and 500mm width. This product falls under HTS 7220.20.10.60 as it is not further worked beyond cold-rolling, has a width of 300mm or more but less than 600mm, and meets the low-chromium specification. Commonly used in automotive trim and appliance exteriors.
Cold-Rolled Martensitic Stainless Sheet 0.5mm x 350mm Low Cr
Thin cold-rolled martensitic stainless steel sheet, 0.5mm thickness by 350mm width, formulated with under 15% chromium for cost-sensitive applications like hardware components. Meets HTS 7220.20.10.60 criteria: cold-reduced only, 300mm+ width <600mm, and low chromium per chapter note (a). Used in cutlery blanks and fasteners.
Ferritic 434 Stainless Steel Cold-Rolled Plate 1.2mm x 550mm
Cold-rolled ferritic grade 434 stainless steel plate with controlled chromium below 15%, 1.2mm thick and 550mm wide for architectural paneling. HTS 7220.20.10.60 applies as not further worked, width 300-600mm range, low Cr content fitting U.S. note exclusions. Offers improved corrosion resistance over carbon steel.
Low Chromium 410S Stainless Cold-Reduced Sheet 0.9mm x 420mm
Grade 410S stainless steel sheet, cold-reduced to 0.9mm x 420mm, with chromium content maintained below 15% for weldability in fabrication. Classifies to HTS 7220.20.10.60: flat-rolled stainless, cold-rolled not further worked, 300mm+ width, low Cr per tariff specs. Used in pressure vessel linings.