Automotive Grade 11Cr Stainless Plate
Flat plate 11% Cr stainless for exhaust manifolds, 1,100 mm width, 5 mm thick. HTS 7219.90.00.60 for other stainless flat-rolled products 600mm+, low Cr, not reinforcing bar type.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If non-stainless alloy steel
Insufficient Cr/Ni for stainless drops to general alloy flat products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• 1
• Automotive certs may trigger additional EPA docs; 2
• Measure uncoiled width; 3
• No rust allowance per Chapter note
Related Products under HTS 7219.90.00.60
AISI 439 Stainless Steel Sheet
Flat-rolled stainless steel sheet conforming to AISI 439 grade with approximately 17% chromium but certified as containing less than 15% by weight overall due to specific alloy composition, width over 600 mm, used in automotive exhaust systems. This falls under HTS 7219.90.00.60 as flat-rolled stainless steel products, not cold-rolled, of width 600 mm or more, other, containing less than 15% chromium. It meets Chapter 72 definitions for stainless steel despite chromium content nuance.
17-4PH Precipitation Hardening Stainless Plate
Hot-rolled flat plate of 17-4PH stainless steel with balanced chromium at 14.5% by weight, width 1,200 mm, thickness 6 mm, for aerospace components. Classified under HTS 7219.90.00.60 for flat-rolled stainless steel over 600 mm width, other categories, low chromium content per note. Not further worked beyond rolling.
Ferritic 409 Stainless Steel Coil
Coiled flat-rolled 409 grade stainless steel with 11% chromium, width 1,000 mm, for muffler manufacturing. HTS 7219.90.00.60 applies to other flat-rolled stainless steel >=600 mm width, <15% Cr, hot-rolled not cold-formed. Excludes razor blade or universal mill plate definitions.
Low Chromium 430 Stainless Steel Sheet
Flat-rolled 430 stainless steel sheet with 14% chromium by weight, 800 mm width, 3 mm thick, for appliance panels. Fits HTS 7219.90.00.60 as other stainless flat products over 600 mm, not meeting 15% Cr threshold or tool steel specs. Hot-rolled finish without polishing.
Martensitic 410 Stainless Steel Plate
Hot-rolled 410 grade stainless plate, 12.5% Cr, 1,500 mm width, 10 mm thick for valve bodies. Under HTS 7219.90.00.60 for stainless flat-rolled >=600 mm, other/other, low Cr content excluding chipper knife steel. Not ball-bearing steel composition.
Duplex 2205 Low Cr Variant Stainless Coil
Coiled duplex stainless with adjusted 13.8% Cr, 900 mm width for chemical tanks. HTS 7219.90.00.60 covers this flat-rolled stainless, width 600mm+, not further worked, below 15% Cr threshold. Excludes high-strength steel yield specs.