Martensitic 410S Stainless Coil
Cold-rolled martensitic Type 410S stainless steel coil, thickness less than 0.5 mm, coil width exceeding 600 mm, certified <15% chromium. Not further worked, for cutlery blanks and valve components. Covered under HTS for low-Cr thin stainless coils.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If of thickness over 1 mm
Thicker than 1 mm cold-rolled stainless moves to 7219.31 thickness category.
If other alloy steel, not stainless
Non-stainless other alloy flat-rolled products in 7225.
If further made into knives/blades
Finished cutlery or interchangeable tools classify in Chapter 82.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Distinguish 410S (lower Cr) from 410; certs must specify <15% Cr for this code
• No burnishing/polishing allowed—pure cold-rolled surface finish required
Related Products under HTS 7219.35.00.30
Ferritic 409 Stainless Steel Coil
Cold-reduced coil of Grade 409 ferritic stainless steel, thickness under 0.5 mm, width over 600 mm, with chromium content under 15% by weight per HTS specification. Not further worked, suitable for exhaust systems and mufflers in automotive manufacturing. Meets Chapter 72 definitions for cold-rolled flat-rolled stainless products.
Appliance Grade 441 Stainless Coil
Thin cold-rolled coil (thickness <0.5 mm, width ≥600 mm) of Type 441 ferritic stainless steel with <15% chromium by weight. Not further worked, used for dishwasher linings, oven trim, and washing machine components. Fits HTS 7219.35.0030 for cold-reduced stainless coils.
Decorative Fascia Stainless Coil
Ultra-thin cold-rolled stainless coil (<0.5 mm thick, ≥600 mm wide) with <15% Cr, for manufacturing decorative fascia panels in home appliances. In coils, cold-reduced only, no further treatments. Matches HTS 7219.35.0030 for thin stainless flat-rolled products.
Exhaust Shield 409CB Stainless Coil
Cold-rolled coil of 409CB stabilized ferritic stainless, under 0.5 mm thickness, 600+ mm width, <15% Cr by weight. For heat shields in vehicle exhaust systems. HTS 7219.35.0030 applies to this not-further-worked cold-reduced stainless product.
Low Cr 3CR12 Stainless Coil
Proprietary 3CR12 utility stainless steel cold-rolled coil (<0.5 mm, >600 mm width, certified <15% Cr). In coils, cold-reduced only, for structural cladding and tanks. Fits precise HTS criteria for thin low-chromium stainless flat products.
HVAC Duct Liner Stainless Coil
Thin-gauge cold-rolled stainless coil (<0.5 mm thick, 600 mm+ width) <15% Cr, for HVAC duct liners and ventilation components. Not further worked, in coil form per HTS 7219.35.0030 for cold-reduced stainless flat-rolled products.