316L Cold-Reduced Stainless Coil 0.3mm Thick
316L stainless steel coil with 10-14% nickel, cold-rolled to 0.3 mm thickness in wide coils (>600 mm), suitable for chemical processing equipment. HTS 7219.35.0015 applies for its mid-range nickel, sub-0.5 mm gauge, and lack of further working like enameling or burnishing.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If nickel content at or above 24% by weight
High-nickel alloys like certain austenitic grades exceed the 24% threshold for this 'other' category.
If not stainless (chromium ≤10.5%)
Non-stainless alloy flat-rolled products cold-rolled in coils classify under heading 7212.
If electrical resistance alloy with specific composition
Specialty stainless with resistance properties may fall under 7220 if certified for electrical use.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include heat analysis reports specifying molybdenum (2-3%) alongside nickel to confirm 316L grade compliance
• Avoid common pitfall of declaring as hot-rolled; cold-reduction is key for this thin gauge subheading
• Declare exact thickness; products exceeding 0.5 mm require different statistical suffix
Related Products under HTS 7219.35.00.15
Type 304 Cold-Rolled Stainless Steel Coil 0.4mm Thick
A flat-rolled stainless steel coil of 0.4 mm thickness, 304 grade with approximately 8-10.5% nickel content, cold-rolled but not further worked, and width exceeding 600 mm. Classified under HTS 7219.35.0015 due to its nickel composition between 0.5% and 24%, thin gauge under 0.5 mm, and coil form without additional surface treatments like polishing or coating.
430 Cold-Rolled Stainless Steel Coil 0.45mm
Thin 430 grade stainless steel coil, 0.45 mm thick with about 0.75% nickel, cold-reduced in coils over 600 mm wide, not further worked. Fits HTS 7219.35.0015 as a low-nickel stainless variant (over 0.5% Ni), distinguished from plain carbon steel by chromium content over 10.5%.
201 Cold-Rolled Stainless Steel Coil 0.48mm
Austenitic 201 grade stainless coil, cold-rolled to 0.48 mm, containing 1-4% nickel, wide format over 600 mm. Matches HTS 7219.35.0015 for cold-rolled stainless not further worked, with nickel >0.5% but <24%, used in cost-sensitive applications like cookware.
Type 439 Cold-Rolled Stainless Coil 0.35mm
Ferritic 439 stainless steel coil with ~1% nickel, cold-reduced to 0.35 mm thickness, coils wider than 600 mm, not further worked. HTS 7219.35.0015 captures its profile: stainless, cold-rolled, thin, mid-nickel range, for exhaust systems and appliances.
301 Half-Hard Cold-Rolled Stainless Coil 0.41mm
301 half-hard stainless steel coil with 6.5-7.5% nickel, cold-rolled to 0.41 mm, wide coils for spring applications. Falls under HTS 7219.35.0015 as not further worked cold-rolled stainless with appropriate nickel content.