Other
Flat-rolled products of stainless steel, of a width of 600 mm or more: > Not further worked than cold-rolled (cold-reduced): > Of a thickness of less than 0.5 mm > In coils: > Containing more than 0.5 percent but less than 24 percent by weight of nickel: > Other
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7219.35.00.15
Type 304 Cold-Rolled Stainless Steel Coil 0.4mm Thick
A flat-rolled stainless steel coil of 0.4 mm thickness, 304 grade with approximately 8-10.5% nickel content, cold-rolled but not further worked, and width exceeding 600 mm. Classified under HTS 7219.35.0015 due to its nickel composition between 0.5% and 24%, thin gauge under 0.5 mm, and coil form without additional surface treatments like polishing or coating.
430 Cold-Rolled Stainless Steel Coil 0.45mm
Thin 430 grade stainless steel coil, 0.45 mm thick with about 0.75% nickel, cold-reduced in coils over 600 mm wide, not further worked. Fits HTS 7219.35.0015 as a low-nickel stainless variant (over 0.5% Ni), distinguished from plain carbon steel by chromium content over 10.5%.
316L Cold-Reduced Stainless Coil 0.3mm Thick
316L stainless steel coil with 10-14% nickel, cold-rolled to 0.3 mm thickness in wide coils (>600 mm), suitable for chemical processing equipment. HTS 7219.35.0015 applies for its mid-range nickel, sub-0.5 mm gauge, and lack of further working like enameling or burnishing.
201 Cold-Rolled Stainless Steel Coil 0.48mm
Austenitic 201 grade stainless coil, cold-rolled to 0.48 mm, containing 1-4% nickel, wide format over 600 mm. Matches HTS 7219.35.0015 for cold-rolled stainless not further worked, with nickel >0.5% but <24%, used in cost-sensitive applications like cookware.
Type 439 Cold-Rolled Stainless Coil 0.35mm
Ferritic 439 stainless steel coil with ~1% nickel, cold-reduced to 0.35 mm thickness, coils wider than 600 mm, not further worked. HTS 7219.35.0015 captures its profile: stainless, cold-rolled, thin, mid-nickel range, for exhaust systems and appliances.
301 Half-Hard Cold-Rolled Stainless Coil 0.41mm
301 half-hard stainless steel coil with 6.5-7.5% nickel, cold-rolled to 0.41 mm, wide coils for spring applications. Falls under HTS 7219.35.0015 as not further worked cold-rolled stainless with appropriate nickel content.