Type 304H High-Carbon Stainless Coil 3.7mm
304H variant stainless steel with elevated carbon, cold-rolled coil 3.7 mm thick, >=600 mm wide, Ni >0.5%. Falls under HTS 7219.32.0038 as other cold-rolled stainless coil not matching tool steel or other special U.S. note definitions.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If high-strength steel specs
If meeting note (a) minimum yield point for thickness, statistical shift within heading.
If thickness >=4.75mm
Upper thickness limit pushes to 'other' flat-rolled stainless.
If ball-bearing steel
Alloys matching note (h) ball-bearing steel composition classify in 7221 bars/rods.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include carbon analysis to differentiate from standard 304; Confirm coil weight limits for containerization; No duty reduction for pre-entry rust per note
Related Products under HTS 7219.32.00.38
Type 304 Cold-Rolled Stainless Steel Coil 3.5mm Thick
A flat-rolled stainless steel coil of Type 304 grade, cold-rolled to a thickness of 3.5 mm and width over 600 mm, containing more than 0.5% nickel. It falls under HTS 7219.32.0038 as it is not further worked beyond cold-rolling, in coils, and meets the specified thickness and nickel content criteria from Chapter 72 notes.
Type 316L Stainless Steel Cold-Reduced Coil 4mm
Cold-reduced Type 316L stainless steel coil, 4 mm thick, over 600 mm wide, with nickel content exceeding 0.5% by weight. Classified under HTS 7219.32.0038 for cold-rolled stainless steel coils of 3-4.75 mm thickness, not further worked, and 'other' compositions per U.S. notes.
17-4PH Precipitation Hardening Stainless Coil 3.2mm
Cold-rolled 17-4PH stainless steel coil, 3.2 mm thickness, width exceeding 600 mm, nickel >0.5%. Fits HTS 7219.32.0038 as 'other' cold-rolled stainless coil not further worked, distinguished from tool steels or other special alloys in U.S. Chapter 72 notes.
Duplex 2205 Stainless Steel Cold Coil 3.8mm Thick
Duplex 2205 grade stainless steel, cold-rolled coil form, 3.8 mm thick, >=600 mm wide, >0.5% Ni. HTS 7219.32.0038 applies to this 'other' stainless category for specified thickness range, coil, cold-reduced without further working.
321 Austenitic Stainless Cold-Rolled Coil 3mm
Type 321 stabilized austenitic stainless steel coil, precisely 3 mm thick cold-rolled, width 700 mm+, nickel >0.5%. Classified in HTS 7219.32.0038 for cold-rolled stainless coils 3mm+ to <4.75mm, 'other' non-specialty per Chapter definitions.
310S Heat-Resistant Stainless Coil 4.2mm
310S high-temperature stainless steel coil, cold-reduced to 4.2 mm, over 600 mm wide, >0.5% Ni but not meeting full heat-resisting steel note (g) due to carbon levels. HTS 7219.32.0038 for 'other' cold-rolled stainless in coils, thickness range.