Hot-Rolled 316L Stainless Steel Sheet 8mm Thick
Grade 316L stainless steel flat-rolled product, hot-rolled to 8 mm thickness with width over 600 mm, not in coil form and without further working. Classified under HTS 7219.22.00 for its hot-rolled stainless steel characteristics within the 4.75-10 mm thickness band and wide format.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If clad or coated with other materials
Cladding or metal/nonmetallic coatings constitute 'further working' per Chapter 72 note, reclassifying to the 'other' hot-rolled stainless steel category.
If processed into boiler/tank sections
When cut and shaped into specific articles for boilers or tanks, it becomes a fabricated article under heading 7304 rather than semi-finished flat-rolled product.
If not stainless (carbon steel equivalent)
Non-stainless hot-rolled carbon steel plates of similar dimensions fall under Chapter 72 carbon steel provisions like 7210.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include heat analysis reports confirming 316L composition (low carbon, molybdenum-enhanced) to distinguish from standard 316 and support stainless steel classification
• Measure width precisely (must exceed 600 mm) and confirm not in coils, as coil form moves to 7219.14 or similar subheadings
• Watch for accidental phosphatizing or other chemical treatments during production, which qualify as 'further worked' and require 7219.90 classification
Related Products under HTS 7219.22.00
Hot-Rolled 304 Stainless Steel Plate 6mm Thick
Flat-rolled stainless steel plate made from grade 304 alloy, hot-rolled to a thickness of 6 mm and width exceeding 600 mm, supplied not in coils and not further worked beyond hot-rolling. This product falls under HTS 7219.22.00 due to its stainless steel composition, specific thickness range of 4.75-10 mm, and lack of additional processing like cold-rolling or surface treatments.
Type 430 Hot-Rolled Stainless Steel Plate 5mm Thick
Ferritic 430-grade stainless steel plate hot-rolled to 5 mm thickness, over 600 mm wide, not coiled and not further worked. Fits HTS 7219.22.00 as a qualifying hot-rolled stainless steel product in the specified thickness range.
Duplex 2205 Hot-Rolled Stainless Plate 7mm
Duplex 2205 (UNS S31803) stainless steel plate, hot-rolled to 7 mm thick and wider than 600 mm, not in coils or further worked. Meets HTS 7219.22.00 criteria for hot-rolled stainless flat products of 4.75-10 mm thickness.
317 Stainless Steel Hot-Rolled Sheet 9.5mm Thick
High-molybdenum 317 stainless steel hot-rolled into 9.5 mm thick sheets over 600 mm wide, not coiled, without further surface treatments. Classified in HTS 7219.22.00 for matching the hot-rolled, thickness, and width specifications for stainless steel.
Type 321 Hot-Rolled Stainless Plate 4.75mm
Titanium-stabilized Type 321 stainless steel plate at minimum 4.75 mm thickness, hot-rolled, wide format over 600 mm, not in coils. Precisely matches HTS 7219.22.00 for hot-rolled stainless flat-rolled products.