317 Stainless Steel Hot-Rolled Coil
Type 317 stainless steel hot-rolled coil, 8 mm thick, 1,000 mm wide, with 3.2% molybdenum and 12% nickel for superior corrosion resistance in marine environments. Fits HTS 7219.12.00.66 due to hot-rolled in coils form, specified thickness, and alloy composition limits. Ideal for heat exchanger plates.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If nickel ≤0.5% by weight
Lower nickel content shifts to the preceding statistical suffix without Mo specification change.
If further worked (e.g., annealed/pickled)
Any surface treatment beyond hot-rolling per Chapter 72 notes moves to 'other' categories.
If imported as tubes made from this material
Products manufactured into tubes or pipes are classified by end form in Chapter 73, not flat-rolled.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Chemical analysis reports must confirm Mo content between 1.5-5% by weight; over 5% changes classification
• Coils must remain in coil form at entry—not slit or leveled, which constitutes further working
• Watch for Section 232 tariffs on steel; additional duties may apply regardless of HTS
Related Products under HTS 7219.12.00.66
Hot-Rolled 316L Stainless Steel Coil
Hot-rolled stainless steel coil, 6 mm thick and 1,200 mm wide, containing 2.5% molybdenum and 11% nickel for enhanced corrosion resistance. Classified under HTS 7219.12.00.66 as flat-rolled stainless steel not further worked than hot-rolled, in coils, 4.75-10 mm thick, with >0.5% Ni and 1.5-5% Mo. Used in chemical processing equipment due to its pitting resistance.
Hot-Rolled 316Ti Stabilized Stainless Coil
316Ti variant stainless steel hot-rolled coil with 2.8% molybdenum, 11.5% nickel, stabilized with titanium, 5 mm thick and 900 mm wide. Meets HTS 7219.12.00.66 criteria for composition and hot-rolled coil form not exceeding 10 mm thickness. Used in welded structures requiring intergranular corrosion resistance.
Marine-Grade 317L Hot-Rolled Steel Coil
Low-carbon 317L stainless steel hot-rolled coil, 7.5 mm thick, 1,500 mm wide, featuring 3.5% molybdenum and 13% nickel for extreme pitting resistance. Classified in HTS 7219.12.00.66 for its hot-rolled coil form and precise alloy specs. Primarily for offshore platforms and desalination plants.
Chemical Processing 316H High-Temp Coil
High-carbon 316H stainless steel hot-rolled coil optimized for elevated temperatures, 4.8 mm thick with 2.2% molybdenum and 10.8% nickel, 1,100 mm wide. Falls under HTS 7219.12.00.66 as hot-rolled stainless coil within thickness range and alloy parameters. Suited for furnace components.