304 High-Strength Stainless Strip 2.5mm x 600mm
High-strength 304 stainless variant (yield >355 MPa for >3mm equiv.), hot-rolled 2.5mm x 600mm strip (ratio>4). HTS 7218.91.00.60 for rectangular semi-finished stainless. Structural components benefit from enhanced yield strength.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If heat-resisting per note (g)
Low-carbon, 4-10.5% Cr stainless classifies under 7222.20 bars/plates.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify minimum yield point per note (a) high-strength steel definition if claiming enhanced properties
Related Products under HTS 7218.91.00.60
304 Stainless Steel Hot-Rolled Strip 1mm x 150mm
Hot-rolled strip of 304 stainless steel with rectangular cross-section, 1mm thick and 150mm wide, meeting the width at least four times thickness criterion (150/1=150>4). Classified under HTS 7218.91.00.60 as a semi-finished stainless steel product, other than square cross-section. Used primarily for further processing into appliances and automotive trim.
316L Stainless Steel Strip 0.8mm x 200mm
Hot-rolled 316L stainless steel strip, 0.8mm thickness by 200mm width (width/thickness=250>4), rectangular cross-section. Falls under 7218.91.00.60 as semi-finished stainless steel bars, not square. Ideal for marine applications and chemical processing equipment due to molybdenum content.
430 Stainless Steel Hot Band 2mm x 500mm
Ferritic 430 stainless hot-rolled band/strip, 2mm thick x 500mm wide (ratio=250>4), rectangular profile. HTS 7218.91.00.60 covers this semi-finished form before cold-rolling or slitting. Commonly used for automotive exhaust systems and appliances.
321 Stainless Steel Stabilized Strip 1.5mm x 300mm
Titanium-stabilized 321 stainless hot-rolled strip, 1.5mm x 300mm (ratio=200>4), rectangular. Under 7218.91.00.60 as other semi-finished stainless with sheet-like dimensions. Used in high-temperature exhaust and aircraft components.
409 Stainless Steel Automotive Strip 1.2mm x 1,000mm
Ferritic 409 stainless hot-rolled strip optimized for exhaust systems, 1.2mm thick x 1,000mm wide (ratio>4). Classifies in 7218.91.00.60 for wide rectangular semi-finished stainless products. Lower chromium content makes it cost-effective for automotive use.
17-4 PH Stainless Precipitation Hardening Strip 0.5mm x 180mm
17-4 PH martensitic precipitation hardening stainless hot-rolled strip, 0.5mm x 180mm (ratio=360>4). HTS 7218.91.00.60 for rectangular semi-finished stainless. Aerospace and valve applications leverage its high strength after heat treatment.