Cold-Rolled Low-Carbon Steel Strip for Automotive Trim
Flat-rolled nonalloy steel strip, cold-rolled, under 600 mm width, thickness 0.8 mm, less than 0.25% carbon, not clad, plated or coated. Used for manufacturing decorative trim in car interiors. Falls under HTS 7211.23.60.60 due to precise dimensional specs and minimal carbon content with no further working.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If hot-rolled instead of cold-rolled
Hot-rolled products of similar specs shift to Chapter 72 heading 7212 for nonalloy steel.
If clad, plated or coated
Any surface treatment like coating moves to 7217 as 'further worked' per chapter notes.
If alloy steel composition
Exceeding nonalloy limits (e.g., added chromium) classifies under alloy steel headings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify carbon content certification below 0.25% to avoid reclassification to higher carbon headings
• Measure width precisely under 600mm; exceeding triggers 7211.29 codes
• Provide mill test reports confirming cold-rolled status without coatings to prevent disputes
Related Products under HTS 7211.23.60.60
Cold-Reduced Steel Sheet for Appliance Housings
Cold-rolled nonalloy steel sheet, 0.6 mm thick, 450 mm wide, <0.25% carbon, uncoated for washer/dryer panels. Not further worked beyond cold-reduction. Matches HTS 7211.23.60.60 for thin, narrow low-carbon flat products.
Narrow Cold-Rolled Steel for Razor Blade Blanks
Thin cold-rolled nonalloy steel strip, 0.3 mm thick, 500 mm wide, <0.25% C, used as base for razor blanks before stainless conversion. Not plated or further worked. Fits 7211.23.60.60 for low-carbon cold-reduced products.
Cold-Rolled Low-Carbon Steel for Bicycle Frames
Cold-reduced steel strip 1.0 mm thick, 550 mm wide, <0.25% carbon, uncoated for bicycle frame tubing feedstock. Minimal processing beyond cold-rolling. Classified under HTS 7211.23.60.60 for narrow low-carbon flats.
Precision Cold-Rolled Steel Shim Stock
High-precision cold-rolled nonalloy steel, 0.4 mm thick, 300 mm wide coil stock, <0.25% C for shim manufacturing. No cladding or coatings applied. HTS 7211.23.60.60 covers this thin cold-reduced category.
Cold-Rolled Steel for Lock Components
Narrow cold-reduced nonalloy steel strip, 0.7 mm x 400 mm, <0.25% carbon, supplied bright finish uncoated for lock tumblers. Not further worked than cold-rolled. Direct fit for 7211.23.60.60 specs.
Low-Carbon Cold Strip for Office Furniture
Cold-rolled nonalloy steel strip 1.1 mm thick, 580 mm wide, <0.25% C for drawer slides in metal office furniture. Uncoated, not clad. HTS 7211.23.60.60 for narrow cold-reduced low-carbon products.