Of a thickness exceeding 0.25 mm but not exceeding 1.25 mm
Flat-rolled products of iron or nonalloy steel, of a width of less than 600 mm, not clad, plated or coated: > Not further worked than cold-rolled (cold-reduced): > Containing by weight less than 0.25 percent of carbon: > Other > Of a thickness exceeding 0.25 mm but not exceeding 1.25 mm
Duty Rate (from China)
Except for products described in headings 9903.03.02–9903.03.11, articles the product of any country, as provided for in subdivision (aa) of U.S. note 2 to this subchapter
Effective with respect to entries on or after September 27, 2024, articles the product of China, as provided for in subdivision (b) of U.S. note 31 to this subchapter
Products classified under HTS 7211.23.60.60
Cold-Rolled Low-Carbon Steel Strip for Automotive Trim
Flat-rolled nonalloy steel strip, cold-rolled, under 600 mm width, thickness 0.8 mm, less than 0.25% carbon, not clad, plated or coated. Used for manufacturing decorative trim in car interiors. Falls under HTS 7211.23.60.60 due to precise dimensional specs and minimal carbon content with no further working.
Cold-Reduced Steel Sheet for Appliance Housings
Cold-rolled nonalloy steel sheet, 0.6 mm thick, 450 mm wide, <0.25% carbon, uncoated for washer/dryer panels. Not further worked beyond cold-reduction. Matches HTS 7211.23.60.60 for thin, narrow low-carbon flat products.
Narrow Cold-Rolled Steel for Razor Blade Blanks
Thin cold-rolled nonalloy steel strip, 0.3 mm thick, 500 mm wide, <0.25% C, used as base for razor blanks before stainless conversion. Not plated or further worked. Fits 7211.23.60.60 for low-carbon cold-reduced products.
Cold-Rolled Low-Carbon Steel for Bicycle Frames
Cold-reduced steel strip 1.0 mm thick, 550 mm wide, <0.25% carbon, uncoated for bicycle frame tubing feedstock. Minimal processing beyond cold-rolling. Classified under HTS 7211.23.60.60 for narrow low-carbon flats.
Precision Cold-Rolled Steel Shim Stock
High-precision cold-rolled nonalloy steel, 0.4 mm thick, 300 mm wide coil stock, <0.25% C for shim manufacturing. No cladding or coatings applied. HTS 7211.23.60.60 covers this thin cold-reduced category.
Cold-Rolled Steel for Lock Components
Narrow cold-reduced nonalloy steel strip, 0.7 mm x 400 mm, <0.25% carbon, supplied bright finish uncoated for lock tumblers. Not further worked than cold-rolled. Direct fit for 7211.23.60.60 specs.
Low-Carbon Cold Strip for Office Furniture
Cold-rolled nonalloy steel strip 1.1 mm thick, 580 mm wide, <0.25% C for drawer slides in metal office furniture. Uncoated, not clad. HTS 7211.23.60.60 for narrow cold-reduced low-carbon products.