Hot-Rolled Black Steel Anneal Base 400 mm Wide
Black finish hot-rolled nonalloy steel, 400 mm width, 2.8 mm thick, base for annealing but imported pre-anneal without further work. HTS 7211.19.75 covers this as other uncoated narrow hot-rolled flat-rolled product.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness over 1.875 mm but not over 4.75 mm specific
Intermediate thickness subheading within 7211.19 for precise gauge control.
If further worked than cold-rolled but not coated
Additional processing beyond cold-rolling (but not coating) goes to 7214.
If alloy tool steel meeting ball-bearing specs
U.S. note (h) ball-bearing steel alloys classify under 7226 series.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Distinguish 'black' mill scale from coated; scale is natural hot-roll, not further worked
• Chemical analysis required to exclude chipper knife steel compositions
Related Products under HTS 7211.19.75
Hot-Rolled Narrow Steel Strip for Automotive Trim
A flat-rolled nonalloy steel strip, 150 mm wide and 3 mm thick, hot-rolled without further surface treatment like plating or coating. It falls under HTS 7211.19.75 as it is not further worked than hot-rolled, under 600 mm width, and classified as 'other' flat-rolled products of iron or nonalloy steel.
Hot-Rolled Steel Sheet for HVAC Duct Fabrication
Flat-rolled iron or nonalloy steel sheet, 450 mm wide and 2.5 mm thick, supplied in hot-rolled condition without any coating or cladding. Classified under HTS 7211.19.75 for narrow (<600 mm) hot-rolled products not further worked than hot-rolling, in the 'other' category.
Narrow Hot-Rolled Mild Steel Band for Packaging
Hot-rolled nonalloy steel band, 50 mm wide and 1.8 mm thick, used for strapping and packaging, without plating or further processing. It matches HTS 7211.19.75 as 'other' flat-rolled products of iron/nonalloy steel, width <600 mm, hot-rolled only.
Industrial Hot-Rolled Low Carbon Steel Sheet 500 mm
Low carbon nonalloy steel sheet, 500 mm width, 4 mm thickness, hot-rolled mill finish for industrial fabrication. HTS 7211.19.75 applies to this 'other' category of narrow, uncoated hot-rolled flat products.
Narrow Hot-Rolled Steel for DIY Metalworking
Hot-rolled mild steel flat, 100 mm wide, 3.2 mm thick, uncoated for hobbyist metalworking projects. Fits HTS 7211.19.75 as other narrow (<600 mm) nonalloy steel products not further worked than hot-rolling.
Hot-Rolled Mild Steel Checkered Pattern Sheet
Mild steel sheet 580 mm wide, 2 mm thick, with raised pattern from rolling process, uncoated. While patterned, as hot-rolled only (no relief patterns excluded in notes), it falls under HTS 7211.19.75 'other' narrow products.