Hot-Rolled Steel Sheet for HVAC Duct Fabrication
Flat-rolled iron or nonalloy steel sheet, 450 mm wide and 2.5 mm thick, supplied in hot-rolled condition without any coating or cladding. Classified under HTS 7211.19.75 for narrow (<600 mm) hot-rolled products not further worked than hot-rolling, in the 'other' category.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If cold-rolled rather than hot-rolled
Cold-rolling constitutes further working beyond hot-rolling, classified under 7211.29 for not further worked than cold-rolled.
If clad, plated, or coated
Any cladding, plating, or coating (e.g., zinc) moves to heading 7212 regardless of width or rolling process.
If of a nominal thickness exceeding 10 mm
Thicker products over 10 mm thick fall under 7208 for ingots/blooms, not flat-rolled under 7211.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include heat analysis certificate confirming nonalloy steel and hot-rolled mill finish
• Measure and document exact width to stay under 600 mm threshold; slight overruns shift to different heading
• Check for unintentional surface treatments; even minor rust prevention coatings disqualify from this code
Related Products under HTS 7211.19.75
Hot-Rolled Narrow Steel Strip for Automotive Trim
A flat-rolled nonalloy steel strip, 150 mm wide and 3 mm thick, hot-rolled without further surface treatment like plating or coating. It falls under HTS 7211.19.75 as it is not further worked than hot-rolled, under 600 mm width, and classified as 'other' flat-rolled products of iron or nonalloy steel.
Narrow Hot-Rolled Mild Steel Band for Packaging
Hot-rolled nonalloy steel band, 50 mm wide and 1.8 mm thick, used for strapping and packaging, without plating or further processing. It matches HTS 7211.19.75 as 'other' flat-rolled products of iron/nonalloy steel, width <600 mm, hot-rolled only.
Industrial Hot-Rolled Low Carbon Steel Sheet 500 mm
Low carbon nonalloy steel sheet, 500 mm width, 4 mm thickness, hot-rolled mill finish for industrial fabrication. HTS 7211.19.75 applies to this 'other' category of narrow, uncoated hot-rolled flat products.
Narrow Hot-Rolled Steel for DIY Metalworking
Hot-rolled mild steel flat, 100 mm wide, 3.2 mm thick, uncoated for hobbyist metalworking projects. Fits HTS 7211.19.75 as other narrow (<600 mm) nonalloy steel products not further worked than hot-rolling.
Hot-Rolled Mild Steel Checkered Pattern Sheet
Mild steel sheet 580 mm wide, 2 mm thick, with raised pattern from rolling process, uncoated. While patterned, as hot-rolled only (no relief patterns excluded in notes), it falls under HTS 7211.19.75 'other' narrow products.
Hot-Rolled Steel Pickling Strip 300 mm Width
Nonalloy steel strip, 300 mm wide, 2 mm thick, hot-rolled and suitable for pickling but supplied without further treatment. Falls under HTS 7211.19.75 as other narrow flat-rolled products not clad, plated, coated, or further worked.