0.48mm Cold-Reduced Mild Steel Sheet
Mild steel sheets cold-reduced to 0.48 mm thick, width 900 mm, in flat form not coiled or further worked. Meets all criteria for HTS 7209.28.00.00: non-alloy, cold-rolled, thin gauge, wide format.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If plated with zinc
Plating/coating excludes from 7209; Chapter notes send to 7212 for coated products.
If formed into boiler plates
Specific end-form into seamless pipes/boilers changes to Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Label shipments clearly as 'cold-rolled not further worked' to match tariff description verbatim
• Budget for potential CBP measurement verification; slight over 0.5 mm thickness reclassifies
• Avoid bulk packaging that causes rust; inspect on arrival as no duty abatement allowed
Related Products under HTS 7209.28.00.00
Cold-Rolled Non-Alloy Steel Sheet 0.4mm Thick
Flat-rolled non-alloy steel sheet, cold-rolled to a thickness of 0.4 mm and width exceeding 600 mm, supplied flat not in coils. This falls under HTS 7209.28.00.00 as it matches the exact criteria of cold-rolled, not further worked, thickness under 0.5 mm, and width 600 mm or more.
0.3mm Thick Cold-Reduced Steel Panel
Cold-reduced flat-rolled iron/non-alloy steel panel measuring 0.3 mm thick and over 700 mm wide, not in coil form and without additional processing. Classified under 7209.28.00.00 due to precise match on cold-rolled specs, thickness, width, and lack of further working.
Cold-Rolled Steel Blank 0.45mm for Appliances
Rectangular cold-rolled non-alloy steel blanks at 0.45 mm thickness, width 800 mm or more, flat/not coiled, used in appliance manufacturing. Fits HTS 7209.28.00.00 as basic cold-rolled product without plating, coating, or further surface treatments.
0.2mm Ultra-Thin Cold-Rolled Steel Sheet
Ultra-thin flat-rolled non-alloy steel sheet cold-rolled to 0.2 mm thickness, width 1000 mm, supplied in flat sheets not coils. This product precisely aligns with HTS 7209.28.00.00 criteria for cold-rolled, non-further-worked thin sheets.
Cold-Rolled Non-Alloy Steel for Automotive Trim
Cold-rolled steel sheets of 0.35 mm thickness and 650 mm width, flat/not in coils, intended for automotive interior trim blanks. Classifies under 7209.28.00.00 as it is basic cold-rolled non-alloy steel without cladding, plating, or further processing.
Precision Cold-Rolled Steel 0.1mm for Electronics
Extremely thin 0.1 mm cold-rolled non-alloy steel sheets over 600 mm wide, flat pack, no coatings or treatments. Perfectly described by HTS 7209.28.00.00 for thinnest cold-rolled category.