0.3mm Thick Cold-Reduced Steel Panel
Cold-reduced flat-rolled iron/non-alloy steel panel measuring 0.3 mm thick and over 700 mm wide, not in coil form and without additional processing. Classified under 7209.28.00.00 due to precise match on cold-rolled specs, thickness, width, and lack of further working.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness of 0.5 mm or more
Thicker cold-rolled sheets in same width range shift to 7209.25 per thickness-based subheadings.
If hot-rolled instead of cold-rolled
Hot-rolled origin products go to 7208, as rolling method determines primary heading.
If clad with another material
Cladding disqualifies from 7209; Chapter notes define clad products under 7212.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Declare as 'not further worked' only if no coatings, paintings, or chemical treatments applied post-rolling
• Use precise caliper measurements for thickness; CBP may inspect for accuracy to confirm sub-0.5 mm status
• Include commercial invoice specifying cold-rolling process and non-alloy steel grade to prevent alloy misclassification
Related Products under HTS 7209.28.00.00
Cold-Rolled Non-Alloy Steel Sheet 0.4mm Thick
Flat-rolled non-alloy steel sheet, cold-rolled to a thickness of 0.4 mm and width exceeding 600 mm, supplied flat not in coils. This falls under HTS 7209.28.00.00 as it matches the exact criteria of cold-rolled, not further worked, thickness under 0.5 mm, and width 600 mm or more.
Cold-Rolled Steel Blank 0.45mm for Appliances
Rectangular cold-rolled non-alloy steel blanks at 0.45 mm thickness, width 800 mm or more, flat/not coiled, used in appliance manufacturing. Fits HTS 7209.28.00.00 as basic cold-rolled product without plating, coating, or further surface treatments.
0.2mm Ultra-Thin Cold-Rolled Steel Sheet
Ultra-thin flat-rolled non-alloy steel sheet cold-rolled to 0.2 mm thickness, width 1000 mm, supplied in flat sheets not coils. This product precisely aligns with HTS 7209.28.00.00 criteria for cold-rolled, non-further-worked thin sheets.
Cold-Rolled Non-Alloy Steel for Automotive Trim
Cold-rolled steel sheets of 0.35 mm thickness and 650 mm width, flat/not in coils, intended for automotive interior trim blanks. Classifies under 7209.28.00.00 as it is basic cold-rolled non-alloy steel without cladding, plating, or further processing.
0.48mm Cold-Reduced Mild Steel Sheet
Mild steel sheets cold-reduced to 0.48 mm thick, width 900 mm, in flat form not coiled or further worked. Meets all criteria for HTS 7209.28.00.00: non-alloy, cold-rolled, thin gauge, wide format.
Precision Cold-Rolled Steel 0.1mm for Electronics
Extremely thin 0.1 mm cold-rolled non-alloy steel sheets over 600 mm wide, flat pack, no coatings or treatments. Perfectly described by HTS 7209.28.00.00 for thinnest cold-rolled category.