High-Strength Cold-Rolled Steel for Elevator Car Bodies
0.95 mm x 1,300 mm wide cold-rolled high-strength steel coil, 390 MPa minimum yield, for elevator cabin wall panels. HTS 7209.17.00.60 for cold-rolled nonalloy high-strength steel coils 0.5-1 mm thick, other than excluded types. Direct match to chapter high-strength steel definition.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If hot-rolled ≥4mm thick
Hot-rolled products in coils of different thickness ranges classified in 7208 series.
If enameled surface
Enameled coatings qualify as nonmetallic further working per chapter note.
If finished elevator panels
Fabricated/completed panels treated as other steel articles in Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• ,Request advance ruling if borderline high-strength specs to avoid entry redelivery
• Coil ID markings should be visible for CBP verification without uncoiling
Related Products under HTS 7209.17.00.60
Cold-Rolled High-Strength Steel for Furniture Frames
0.85 mm x 700 mm wide high-strength cold-rolled steel coil, 345 MPa yield, for commercial office furniture structural frames. HTS 7209.17.00.60 applies to this cold-rolled nonalloy high-strength steel in coils, 0.5-1 mm thickness range, not further worked. Conforms exactly to chapter note strength definition.
High-Strength Cold-Rolled Steel Coil for Automotive Panels
Cold-rolled high-strength steel coil, 0.7 mm thick and 1,200 mm wide, with minimum yield strength of 355 MPa, used for outer body panels in vehicles. Classified under HTS 7209.17.00.60 as flat-rolled nonalloy high-strength steel in coils, cold-rolled, thickness 0.5-1 mm, not further worked. Meets chapter note (a) definition for high-strength steel over 3 mm thickness equivalent strength.
High-Strength Steel Coil for Structural Appliances
Cold-rolled nonalloy steel coil, 0.9 mm thick, 900 mm wide, high-strength with 380 MPa yield point, for refrigerator and washer chassis components. Fits HTS 7209.17.00.60 as cold-rolled high-strength steel in coils, 0.5-1 mm thick, not further worked. Conforms to US note (a) high-strength criteria for structural applications.
Automotive High-Strength Cold-Reduced Steel for Door Frames
0.6 mm thick cold-reduced high-strength steel coil, 1,500 mm wide, yield strength 275 MPa minimum, for car door inner frames. HTS 7209.17.00.60 applies to cold-rolled nonalloy high-strength steel coils 0.5-1 mm thick, width ≥600 mm, other than specific exclusions. Meets precise high-strength steel definition in US note (a).
High-Strength Steel Coil for Heavy Equipment Cabinets
Cold-rolled high-strength steel coil 0.8 mm x 1,000 mm wide, 400 MPa yield strength, for tractor and excavator control cabinets. Under HTS 7209.17.00.60 as other high-strength nonalloy steel, cold-rolled in coils, specified thickness range, not clad/plated/coated. Verified against chapter note (a) strength minimums.
Cold-Rolled High-Strength Steel for Solar Panel Frames
0.75 mm thick, 800 mm wide high-strength cold-rolled steel coil with 355 MPa yield, for renewable energy panel mounting frames. HTS 7209.17.00.60 covers this nonalloy flat-rolled product in coils, cold-rolled, high-strength steel 0.5-1 mm thick, other category. Precise fit to US note high-strength specifications.