DP1000/600 Dual Phase Ultra Steel Coil
Ultra high-strength dual phase DP1000/600 steel hot-rolled coil (<3 mm thick, ≥600 mm wide), tensile strength 980-1180 MPa. HTS 7208.39.0020 for 'ultra' advanced HSS per statistical note 4. Used in safety-critical automotive reinforcements.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If in bars/rods form
Long products (bars/rods) of HSS use chapter 72 bar headings like 7213.91.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide phase composition analysis (ferrite-martensite) supporting dual phase designation
• Verify no heat treatment beyond hot-rolling; quenched steels may shift classification
Related Products under HTS 7208.39.00.20
VHSS980 Very High Strength Steel Coil
VHSS980 very high strength hot-rolled coil <3mm, advanced HSS. 7208.39.0020.
980Y1000 Yield Steel Coil
980Y1000 advanced yield strength HSS coil hot-rolled. HTS 7208.39.0020.
Advanced HSS S980MC Steel Coil
S980MC structural advanced HSS hot-rolled coil <3mm ≥600mm. 7208.39.0020.
Advanced High-Strength DP980 Steel Coil
Hot-rolled flat-rolled steel coil of nonalloy steel, width over 600 mm and thickness under 3 mm, classified as high-strength steel with minimum yield point of 695 MPa for DP980 dual-phase grade. Falls under HTS 7208.39.0020 as 'advanced' high-strength steel per statistical note 4, in coils not further worked than hot-rolled. Used primarily in automotive structural components requiring superior formability and strength.
Ultra High-Strength TRIP980 Steel Coil
Hot-rolled nonalloy steel coil featuring TRIP980 (Transformation Induced Plasticity) grade with yield strength exceeding 600 MPa, thickness <3 mm, width ≥600 mm. Classified under 7208.39.0020 as 'ultra' high-strength per statistical note 4, ideal for lightweight automotive body panels. Not further worked beyond hot-rolling, no cladding or coatings.
Advanced Martensitic MS1200 Steel Coil
Hot-rolled coil of martensitic advanced high-strength steel (MS1200) with minimum yield 1050 MPa, flat-rolled <3 mm thick and ≥600 mm wide, nonalloy composition. HTS 7208.39.0020 applies to this 'advanced' grade per statistical note 4, used in crash-resistant vehicle structures. Supplied in hot-rolled coil form without further processing.