Radiata Pine CDX Plywood Panel
CDX grade plywood with Radiata pine coniferous outer plies, suitable for construction subflooring and roofing, 5/8 inch thick. Surface has no covering or only transparent sealer showing wood grain pattern. Meets HTS 4412.59.8000 for other coniferous plywood.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If surface-covered with transparent plastic film
Thin plastic overlays, even if grain-visible, sometimes classify under 4412.59.31 if considered surface covering.
If constructed as blockboard with solid wood core blocks
Blockboard uses lumber core strips between face veneers, distinct from veneer-core plywood.
If imported as individual 2mm thick coniferous veneers
Single wood sawn/coniferous sheets classify under Chapter 44 sawn wood before plywood assembly.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Confirm C-D exposure rating via stamp verification; affects structural import permits
• Test for E0/E1 formaldehyde emissions; EU REACH compliance often required for US imports
• Avoid bundling with hardware; sets with nails/screws may classify under 4418.71
Related Products under HTS 4412.59.80.00
SPF Pine Plywood 3/4 Inch 4x8 Sheet
Standard plywood panel made with both outer plies of SPF (spruce-pine-fir) coniferous wood, core of softwood veneers, measuring 3/4 inch thick by 4x8 feet. Not surface-covered or covered only with transparent finish preserving wood grain and texture. Classifies under 4412.59.8000 as coniferous plywood, other than blockboard/laminboard/battenboard.
Douglas Fir Exterior Sheathing Plywood
Structural plywood for exterior wall sheathing with Douglas fir coniferous face and back veneers, waterproof glue, and no opaque surface covering. Grain and markings remain visible through any clear sealant. Falls under 4412.59.8000 as other coniferous plywood not surface-covered obscuring texture.
Hem-Fir Underlayment Plywood 1/2 Inch
1/2-inch plywood panels with Hem-Fir (hemlock-fir mix) coniferous outer veneers, tongue-and-groove edges for flooring underlayment. No grain-obscuring surface treatment applied. Classified in 4412.59.8000 as other not surface-covered coniferous plywood.
Lodgepole Pine Utility Plywood
Utility grade plywood sheathing with lodgepole pine coniferous face and back veneers, 15/32 inch thickness for general construction. Clear or no surface coating preserves natural wood markings. HTS 4412.59.8000 applies to this other coniferous plywood.
Sitka Spruce Aircraft Grade Plywood
High-quality Sitka spruce coniferous plywood for aircraft and marine applications, with consistent outer plies and no opaque coverings. Grain texture fully visible for strength assessment. Fits 4412.59.8000 as specialty coniferous plywood, other.
Ponderosa Pine Pallet Base Plywood
Heavy-duty 3/4-inch plywood cut for pallet decking and bases, Ponderosa pine coniferous outer veneers, untreated surface. Natural wood grain exposed without coverings. Classifies under HTS 4412.59.8000 other coniferous plywood.