Pitch Pine Furniture Grade Plywood
Furniture component plywood with pitch pine (Pinus rigida) outer veneers, all plies ≤6mm, clear finish only. Classified 4412.39.4039 for specified coniferous southern pine without grain-obscuring cover.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If machined into shutter components
Shaped wooden shutter parts become builders' joinery.
If outer plies are other non-listed coniferous
General coniferous plywood without specific pine designation.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide end-use statements if avoiding furniture heading 9403 classification
• Test for VOC emissions compliance with destination country regs
Related Products under HTS 4412.39.40.39
Southern Yellow Pine Plywood Panel
Plywood panel made solely from sheets of coniferous wood, with both outer plies of southern yellow pine (Pinus taeda) and each ply not exceeding 6 mm thick. Not surface-covered or covered only with transparent material that preserves the wood grain. Falls under 4412.39.4039 due to specific southern pine outer ply and lack of opaque covering.
Loblolly Pine Utility Plywood Sheathing
Construction-grade plywood sheathing with both outer plies of loblolly pine (Pinus taeda), plies ≤6mm thick, no surface covering or only clear coating. Classified in 4412.39.4039 for southern yellow pine group and untreated surface.
Slash Pine Structural Plywood
Structural plywood sheets featuring slash pine (Pinus elliottii) as both outer plies, each ≤6mm, uncovered or with grain-preserving clear coat. Meets 4412.39.4039 criteria for southern pine plywood without surface obscuration.
Shortleaf Pine CDX Plywood
CDX exposure-rated plywood with shortleaf pine (Pinus echinata) outer plies, plies not over 6mm, plain surface or clear protected. 4412.39.4039 applies due to southern pine designation and surface requirements.
Longleaf Pine Underlayment Plywood
Underlayment-grade plywood using longleaf pine (Pinus palustris) for both face and back plies ≤6mm thick, untreated or transparently sealed. Specific southern pine composition qualifies for HTS 4412.39.4039.
Virginia Pine Wall Paneling Plywood
Thin plywood wall paneling sheets with Virginia pine (Pinus virginiana) both outer plies ≤6mm, natural grain exposed or UV clear coated. Meets precise 4412.39.4039 for southern pine group.