Engelmann Spruce Molded Casing Strips
Engelmann spruce door/window casing with molded (ogee) edge profiles for interior trim. Continuously shaped coniferous wood strips, end-matched but unassembled, HTS 4409.10.90.40.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If planed spruce without molding
Sanded four sides spruce is basic coniferous lumber.
If with marquetry inlays
Decorative inlaid wood casings use Chapter 44 ornamented wood.
If colonial hardwood moldings
Same profile in mahogany/teak uses non-coniferous heading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Complex molding requires cross-section drawings for CBP review
• Pre-primed? Becomes painted joinery under 4418
• Length standardization aids strip vs plank distinction
Related Products under HTS 4409.10.90.40
Pine Tongue and Groove Siding
Pine wood siding boards continuously shaped with tongue and groove along the edges for seamless interlocking installation on exterior walls. These coniferous wood strips are planed and sanded but not assembled, falling under HTS 4409.10.90.40 as 'other' coniferous wood continuously shaped along edges.
Spruce V-Jointed Shiplap Boards
Spruce shiplap boards featuring V-jointed edges for overlapping installation in wall paneling or ceilings. These coniferous strips are continuously shaped along edges, sanded for finish, and unassembled, classified in HTS 4409.10.90.40 as other shaped coniferous wood.
Fir Chamfered Edge Decking
Fir wood decking strips with chamfered edges for aesthetic finish and water runoff in outdoor flooring applications. Continuously shaped along edges and end-jointed but not assembled, these coniferous products fit HTS 4409.10.90.40.
Cedar Beaded Panel Molding
Western red cedar molding strips with beaded profiles along edges for decorative wall paneling trim. These planed, sanded coniferous wood pieces are continuously shaped but supplied unassembled, under HTS 4409.10.90.40.
Hemlock Rebated Edge Cladding
Hemlock wood cladding boards with rebated (rabbeted) edges for shadow gap detailing in modern architecture. Continuously shaped coniferous strips, end-jointed and sanded, classified as other under HTS 4409.10.90.40.
Pine Molded Baseboard Strips
Pine strips molded with classic baseboard profiles (rounded and beaded edges) for floor-wall transitions. These coniferous wood moldings are continuously shaped along faces/edges, planed but not assembled, under HTS 4409.10.90.40.