Pine Molded Baseboard Strips
Pine strips molded with classic baseboard profiles (rounded and beaded edges) for floor-wall transitions. These coniferous wood moldings are continuously shaped along faces/edges, planed but not assembled, under HTS 4409.10.90.40.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If planed pine without molding profile
Basic surfaced four sides (S4S) pine is unfinished lumber.
If bundled as complete baseboard sets
Sets with multiple molding types become builders' joinery.
If densified/impregnated versions
Compressed or chemically treated molded wood uses 4413.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Profile cross-sections must show molding; simple rounded edges alone may be 4407
• Length under 3m typical for strips; longer pieces risk floorboard classification
• No pre-cut miters; angled ends make them Chapter 44 joinery
Related Products under HTS 4409.10.90.40
Pine Tongue and Groove Siding
Pine wood siding boards continuously shaped with tongue and groove along the edges for seamless interlocking installation on exterior walls. These coniferous wood strips are planed and sanded but not assembled, falling under HTS 4409.10.90.40 as 'other' coniferous wood continuously shaped along edges.
Spruce V-Jointed Shiplap Boards
Spruce shiplap boards featuring V-jointed edges for overlapping installation in wall paneling or ceilings. These coniferous strips are continuously shaped along edges, sanded for finish, and unassembled, classified in HTS 4409.10.90.40 as other shaped coniferous wood.
Fir Chamfered Edge Decking
Fir wood decking strips with chamfered edges for aesthetic finish and water runoff in outdoor flooring applications. Continuously shaped along edges and end-jointed but not assembled, these coniferous products fit HTS 4409.10.90.40.
Cedar Beaded Panel Molding
Western red cedar molding strips with beaded profiles along edges for decorative wall paneling trim. These planed, sanded coniferous wood pieces are continuously shaped but supplied unassembled, under HTS 4409.10.90.40.
Hemlock Rebated Edge Cladding
Hemlock wood cladding boards with rebated (rabbeted) edges for shadow gap detailing in modern architecture. Continuously shaped coniferous strips, end-jointed and sanded, classified as other under HTS 4409.10.90.40.
Douglas Fir Rounded Edge Fascia
Douglas fir fascia boards with rounded edges for roofline trim protection against weather. Coniferous wood continuously shaped along top/bottom edges, sanded and end-jointed, fits HTS 4409.10.90.40 other category.