Ground Tobacco Stems for Snuff Production

Ground tobacco stems, pulverized into fine particles from tobacco refuse, used as a base material in dry snuff manufacturing. Fits HTS 2401.30.25.90 as cut/ground/pulverized stems for non-cigarette products like snuff. These stems are threshed remnants valued for their nicotine content in oral tobacco blends.

Import Duty Rates by Country of Origin

Origin CountryMFN RateCh.99 SurchargesTotal Effective Rate
🇨🇳ChinaFree+35.0%35%
🇲🇽MexicoFree+10.0%10%
🇨🇦CanadaFree+10.0%10%
🇩🇪GermanyFree+10.0%10%
🇯🇵JapanFree+10.0%10%

Alternative Classifications

This product could be classified differently depending on its characteristics or intended use.

2401.30.37Same rate: 35%

If stems are whole, not ground/pulverized

Processing level determines subheading; whole stems go to uncut refuse categories.

2403.91.45Lower: 17.5% vs 35%

If prepared as 'plug' or 'twist' smokeless tobacco

Further processing into consumer-ready forms classifies under manufactured 'other' smokeless tobacco.

2401.20.33Same rate: 35%

If from cigar leaf tobacco type

Base tobacco type (flue-cured vs cigar) changes the primary refuse heading.

Not sure which classification is right?

Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.

Import Tips & Compliance

Include lab analysis confirming particle size (ground/pulverized) and non-cigarette end-use to support classification

Check U.S

Note quotas for origins like Philippines or Thailand; exceedance triggers higher general rates

Label shipments clearly as 'tobacco stems for snuff' to avoid CBP scrutiny as unmanufactured leaf

Related Products under HTS 2401.30.25.90

Cut Tobacco Stems for Pipe Blending

These are cut tobacco stems derived from flue-cured tobacco leaves, processed by cutting into small pieces for blending into pipe tobacco mixtures. Classified under HTS 2401.30.25.90 as tobacco refuse (stems) that is cut and intended for use in products other than cigarettes, such as pipe tobacco or chewing tobacco. The stems provide structural bulk and flavor base without being manufactured into cigarette filler.

Pulverized Tobacco Stems for Chewing Tobacco Base

Pulverized stems from threshed tobacco leaves, reduced to powder form for use in loose-leaf chewing tobacco recipes. Under HTS 2401.30.25.90 as pulverized tobacco refuse stems for non-cigarette oral products. Commonly sourced from low-grade leaf trimmings for cost-effective blending.

Cut Flue-Cured Stems for Hookah Tobacco Filler

Cut stems from flue-cured Virginia tobacco, processed for mixing into hookah (water pipe) tobacco bases excluding glycerol mixtures. HTS 2401.30.25.90 covers these as cut stems for non-cigarette smoking products. Used by blenders to extend premium leaf tobaccos economically.

Ground Oriental Tobacco Stems for Roll-Your-Own

Ground stems from Oriental-type tobacco refuse, pulverized for blending into roll-your-own (RYO) tobacco, distinct from cigarette factory use. Classed in 2401.30.25.90 for ground stems in non-cigarette products like RYO hand-rolling. Oriental stems add aromatic qualities to custom blends.

Pulverized Burley Stems for Dissolvable Tobacco

Pulverized Burley tobacco stems, air-cured refuse ground fine for dissolvable oral tobacco products. HTS 2401.30.25.90 applies to pulverized stems for innovative non-cigarette tobacco like strips or orbs. Burley provides neutral base for flavor infusion.