Radiation Detector Interface PCA
This printed circuit assembly interfaces gamma and X-ray detectors in instruments of heading 90.30, converting analog signals to digital for analysis. It is designed for ionizing radiation measurement apparatus. As a dedicated part, it falls under tariff item 9030.90.00.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | — | Free |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If imported as a complete radiation detector instrument
Complete instruments are classified under the instrument heading.
If the PCA is essentially a general-purpose signal processor
General electronic components are classified in Chapter 85.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Declare the PCA as a part of ionizing radiation measurement instruments
• Keep technical documentation showing the signal conversion function
• No import permits are required for this classification
Related Products under Tariff item 9030.90.00
4-Channel Analog Front-End PCA for Benchtop Scopes
A multi-channel printed circuit assembly with track/hold amplifiers and 12-bit ADCs, designed specifically for 4-channel benchtop oscilloscopes up to 500MHz. This PCA is a dedicated part for oscilloscopes of subheading 9030.10, as it conditions and digitizes analog signals for measurement.
9030.82 Ionizing Radiation Control PCA
A control printed circuit assembly for apparatus detecting cosmic and other ionizing radiations under heading 90.30. It manages power, data acquisition, and alarms for radiation detection instruments. As a dedicated part for ionizing radiation measurement apparatus, it falls under tariff item 9030.90.00.
Active FET Oscilloscope Probe
A low-noise active FET probe for high-impedance oscilloscope measurements up to 1GHz bandwidth, powered via scope auxiliary port. This probe is an accessory for oscilloscopes of subheading 9030.10, enhancing measurement capabilities.
Bertscope Bit Error Rate PCA
A printed circuit assembly for bit error rate testing in high-speed oscilloscopes of heading 90.30. It generates patterns and measures electrical eye diagrams for signal integrity analysis. As a dedicated part for oscilloscopes, it is classified under tariff item 9030.90.00.
BNC Feedthrough Termination 50 Ohm
A 50-ohm BNC feedthrough terminator for oscilloscope inputs, preventing signal reflections and protecting front-end amplifiers. This accessory is used with oscilloscopes of subheading 9030.10 for accurate impedance matching.
Deskliew Deskew Fixture for Probes
A deskew calibration fixture for dual-probe channel timing alignment in oscilloscopes, generating simultaneous signals via SMB. This fixture is essential for accurate differential measurements with oscilloscopes of subheading 9030.10.