Hot-Rolled Steel Coil 11mm Thick for Bridge Construction
Flat-rolled nonalloy steel coil, hot-rolled to 11 mm thickness and 1500 mm width, not further worked, for structural beams in bridge girders. It falls under this tariff item as its thickness exceeds 10 mm.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | +50.0% | 50% |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness is 10 mm to 25 mm
This item covers hot-rolled coils with thickness over 10 mm but not exceeding 25 mm.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Verify the product is not clad, plated, or coated
• Keep records of the steel's chemical composition to confirm nonalloy status
• Check if the bridge project is subject to any federal procurement requirements
Related Products under Tariff item 7208.36.00
Heavy Gauge Hot-Rolled Steel Coil 20mm Thick for Pressure Vessels
Heavy gauge hot-rolled nonalloy steel coil, 20 mm thick and 1800 mm wide, uncoated and not further worked. Designed for fabricating pressure vessel shells in petrochemical plants, it meets the tariff item's requirement of a thickness exceeding 10 mm.
Heavy Hot-Rolled Nonalloy Coil 14mm for Wind Tower Bases
Hot-rolled nonalloy steel coil, 14 mm thick and 1700 mm wide, for wind turbine tower foundations. Uncoated and not further worked, it falls under this tariff item because its thickness exceeds 10 mm.
High-Strength Hot-Rolled Steel Coil for Heavy Machinery Frames
Hot-rolled steel coil of thickness exceeding 10 mm and width over 600 mm, classified as high-strength steel with a minimum yield point of 355 MPa. It is not clad, plated, coated, or further worked beyond hot-rolling, and is used for heavy machinery frames.
High-Strength Hot-Rolled Steel for Mining Conveyor Frames
High-strength steel coil, hot-rolled, over 10 mm thick and over 600 mm wide, with a minimum yield of 355 MPa, in coils and not further worked. It is used for structural framing in heavy-duty mining conveyor systems.
High-Strength Hot-Rolled Steel for Offshore Platform Fabrication
Coiled hot-rolled nonalloy steel plate exceeding 10 mm thick and 600 mm wide, certified high-strength with a yield strength of at least 355 MPa. It is supplied not further worked for cutting into plates for oil rig and offshore platform fabrication.
High-Strength Hot-Rolled Steel for Wind Turbine Towers
Flat-rolled nonalloy high-strength steel in hot-rolled coils, thickness exceeding 10 mm and width at least 600 mm, with a yield strength of at least 355 MPa. It is not clad, coated, or further worked, and is used for wind turbine towers.