Low Carbon Steel Ingot 500kg
A 500kg rectangular ingot of non-alloy low-carbon steel, containing less than 0.25% carbon. It is a primary form used before secondary processing into billets or slabs, and is classified as a semi-finished product under this item.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | +50.0% | 50% |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If the ingot has obvious surface faults and does not meet the chemical composition of pig iron or ferro-alloys
Such ingots are classified as remelting scrap ingots under heading 72.04.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Confirm the ingot is not a remelting scrap ingot, which is defined in chapter note 1(g) and excluded from this heading
• Provide evidence that the ingot has not been further worked than roughly shaped by forging
• Check the carbon content with a certified analysis
Related Products under Tariff item 7207.19.00
Basic Oxygen Furnace Billet Low Carbon
A 110x110mm billet produced by a basic oxygen furnace, made of non-alloy steel with a carbon content below 0.25%. It is a semi-finished product intended for further hot working into bars, rods, or other shapes, and is not yet an article of another heading.
Continuous Cast Steel Billet 120mm
A 120mm round or square billet produced by continuous casting, made of non-alloy steel with less than 0.25% carbon. It is a semi-finished product used as feedstock for wire rod or bar production, and has not been further worked beyond casting.
Low Carbon Slab for Automotive Sheet
A 220mm thick slab of non-alloy steel with a carbon content below 0.25%, produced for rolling into automotive body sheets. It is a semi-finished product, cast and not further worked, and is classified under this item as 'other' low-carbon semi-finished steel.
Low Carbon Steel Billet 100x100mm
A square semi-finished billet of non-alloy steel with less than 0.25% carbon, measuring 100mm x 100mm in cross-section. It is used for hot rolling into bars or shapes and has not been further worked beyond casting or primary hot-rolling.
Low Carbon Steel Semifinished for Pipe
A 250mm thick slab of non-alloy steel with less than 0.25% carbon, produced as a semi-finished product for seamless pipe manufacturing. It is cast and not further worked, and falls under this item as 'other' low-carbon semi-finished steel.
Nonalloy Steel Bloom 150x150mm
A rectangular semi-finished bloom of low-carbon non-alloy steel, measuring 150mm x 150mm, produced by continuous casting. It is used for rolling into plates or structural sections and has not been further worked, qualifying for this item.