GMC Sierra Aluminum Front Bumper Valance Stamping
Aluminum stamping for the lower valance panel in GMC Sierra front bumpers. This part is under HTS 8708.10.30.30 as a bumper-specific aluminum stamping for heavy trucks in 8701-8705. Provides aerodynamic shaping and debris protection.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If steel construction
8708.29 covers steel bumpers and parts, separate from aluminum.
If aluminum plates over 0.2mm, pre-stamping
Raw material sheets before stamping classify in Chapter 76.
If other aluminum bumpers not stampings
Non-stamping aluminum bumpers (e.g., cast) use different subheading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Photographic evidence of stamping process aids classification disputes
• Avoid mixing with painted parts in same container to prevent assembly claims
• Check for Section 232 tariffs on aluminum auto parts from certain origins
Related Products under HTS 8708.10.30.30
Ford F-150 Aluminum Front Bumper Stamping
This is a die-stamped aluminum panel forming the main structural component of the front bumper for Ford F-150 pickup trucks. It falls under HTS 8708.10.30.30 as a bumper stamping made of aluminum for motor vehicles in headings 8701 to 8705. The stamping process creates the shaped form without further assembly.
Tesla Model 3 Rear Aluminum Bumper Stamping
A precision-stamped aluminum sheet forming the outer shell of the rear bumper for Tesla Model 3 electric sedans. Classified under HTS 8708.10.30.30 due to its aluminum construction and role as a bumper stamping for passenger vehicles in heading 8703. It requires no further forming before assembly.
Ram 1500 Aluminum Front Bumper Center Stamping
Stamped aluminum forming the center section of the front bumper for Ram 1500 heavy-duty trucks. This part is under HTS 8708.10.30.30 as an aluminum bumper stamping designed exclusively for motor vehicles of heading 8704. It provides structural support and impact absorption.
Chevrolet Silverado Aluminum Bumper Side Panel Stamping
Die-formed aluminum stamping for the side extension panels of Chevrolet Silverado bumpers. Falls in HTS 8708.10.30.30 as a dedicated aluminum part for truck bumpers under headings 8701-8705. Used in assembly lines for high-strength, lightweight construction.
Toyota Tacoma Aluminum Rear Bumper Stamping
Stamped aluminum component forming the main body of the rear bumper for Toyota Tacoma midsize trucks. Classified in HTS 8708.10.30.30 for its aluminum material and stamping process tailored to motor vehicles of heading 8704. Enhances fuel efficiency through weight reduction.
Rivian R1T Aluminum Bumper Reinforcement Stamping
High-strength stamped aluminum reinforcement for Rivian R1T electric truck bumpers. HTS 8708.10.30.30 applies as an aluminum stamping integral to motor vehicle bumpers under heading 8704. Designed for crash energy management.