Cast Iron Turbine Shaft Bearing Pedestal
Rough cast iron pedestal housing turbine shaft bearings in power generation gas turbines, cleaned/machined minimally. HTS 8411.99.1010 classification applies.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If independent bearing housings
Principal function as bearing housing trumps turbine part.
If coated/non-machinery castings
Machinery castings requiring paint/coating classify differently.
If complete engine subassemblies
Mounted bearing assemblies become other engine parts.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Pedestal alignment faces must be rough cast
• Oil sump provisions unmachined for qualification
• Vibration specs documented for end-use
Related Products under HTS 8411.99.10.10
Cast Iron Turbine Frame Cross Brace
Rough cast iron cross bracing for structural turbine frame in nonaircraft gas turbines, minimal machining for assembly. HTS 8411.99.1010 nonaircraft part.
Cast Iron Gas Turbine Liner Support
Cast iron support structure holding combustion liners in gas turbine combustors, rough with locator machining only. Fits HTS 8411.99.1010 for nonaircraft rough parts.
Cast Iron Exhaust Collector Box
Rough cast iron box collecting exhaust from multiple turbine stages in industrial gas turbines, basic machining only. Nonaircraft part under HTS 8411.99.1010.
Cast Iron Transition Duct Casting
Rough cast iron duct transitioning hot gas between turbine stages in stationary gas turbines, cleaned with locator holes. Classifies HTS 8411.99.1010.
Cast Iron Gas Turbine Compressor Casing
A rough-machined cast iron housing for the compressor section of industrial gas turbines used in power generation. It is cast from iron, cleaned, and machined only to remove fins, gates, sprues, risers, or for fixture location, fitting HTS 8411.99.1010 as a part of nonaircraft gas turbines not advanced beyond basic preparation.
Cast Iron Turbine Inlet Scroll
Rough cast iron scroll-shaped volute that directs airflow into the turbine stage of stationary gas turbines. Cleaned and minimally machined only for casting defect removal and assembly fixturing, classified under HTS 8411.99.1010 for nonaircraft gas turbine parts.