Cast Iron Turboprop Turbine Case
Rough cast-iron outer case for the turbine section in turbopropeller engines. Limited to cleaning and machining solely for fin, gate, sprue, and riser removal or finishing machine location. Meets HTS 8411.91.10 as an unfinished cast-iron part dedicated to turbopropellers.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If for industrial gas turbines, not aircraft turbojets/turboprops
Cast-iron parts of stationary gas turbines used in power generation classify under separate subheading for non-aircraft turbines.
If sold in bulk without turbojet specification
Unspecified or general-purpose cast-iron castings fall under Chapter 73 as other cast iron products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include engineering drawings showing part is for turboprop turbine and machining is minimal per HTS note
• Avoid classifying with steel parts; confirm iron content >95% via material test reports
Related Products under HTS 8411.91.10
Cast Iron Turbojet Compressor Housing
A rough cast-iron housing designed for the compressor section of a turbojet engine. It is cleaned and minimally machined only to remove casting imperfections like fins, gates, sprues, and risers, or for fixture placement in further finishing. Classified under HTS 8411.91.10 as a basic cast-iron part of turbojets not advanced beyond initial cleaning and minimal machining.
Cast Iron Turbojet Inlet Duct Casting
Basic cast-iron component forming the air inlet duct for turbojet engines. Processed only by cleaning and minimal machining to eliminate casting defects or enable fixturing. Falls under 8411.91.10 for its specific use in turbojet air intake systems.
Cast Iron Turboprop Gearbox Housing
Rough cast-iron housing for the reduction gearbox in turboprop engines. Machined only to remove fins, gates, sprues, risers, or for locating in finishing equipment. Specifically provided for in HTS 8411.91.10 as a turbopropeller part.
Cast Iron Turbojet Exhaust Nozzle Flange
Unfinished cast-iron flange for attaching exhaust nozzles in turbojet engines. Limited processing includes cleaning and machining only for casting defect removal or fixturing. HTS 8411.91.10 applies to such basic turbojet cast-iron components.
Cast Iron Turboprop Impeller Mounting Base
Rough cast-iron base plate for mounting impellers in turboprop compressors. Cleaned and minimally machined solely to remove sprues, risers, fins, gates, or for finishing fixture location. Qualifies under HTS 8411.91.10 for turboprop parts.
Cast Iron Turbojet Combustion Chamber Support
Basic cast-iron support bracket for turbojet combustion chambers. Features only cleaning and machining to eliminate casting artifacts or permit finishing machine placement. Covered by HTS 8411.91.10 as unfinished turbojet cast-iron part.