Cast Iron Turboprop Turbine Blade Rough Casting
Rough cast iron turbine blade for turboprop engines used in non-aircraft applications like marine propulsion, cleaned and lightly machined only to remove sprues and risers. Falls under HTS 8411.91.10.40 for cast-iron parts of turbopropellers not advanced beyond initial preparation stages.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If alloy steel construction or fully machined
Finished or steel turbine blades are classified under other parts of gas turbines, excluding rough cast iron.
If bulk industrial castings without turbine specificity
Unspecified cast iron products for machinery parts default to Chapter 73 material-based classification.
If part of a complete turbocharger assembly
Derived turbocharger parts may fall under turbocharger-specific provisions rather than general turbine parts.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide evidence of turboprop compatibility and non-aircraft end-use to prevent reclassification
• Ensure machining logs show only location-enabling operations, not functional shaping
Related Products under HTS 8411.91.10.40
Cast Iron Turbine Exhaust Collector
Rough cast iron collector for exhaust gases from non-aircraft turbopropellers, cleaned and located-machined only. Fits HTS 8411.91.10.40 for cast-iron parts not beyond initial processing.
Cast Iron Turbojet Compressor Casing
A rough cast iron housing for the compressor section of a non-aircraft turbojet engine, machined only to remove casting imperfections like fins and gates for subsequent finishing. Classified under HTS 8411.91.10.40 as a cast-iron part of turbojets not advanced beyond basic cleaning and machining, specific to non-aircraft turbines.
Cast Iron Turbofan Diffuser Rough Part
Preliminary cast iron diffuser component for non-aircraft turbofan gas turbines, with only fins, gates, and sprues removed for machining setup. Classified in HTS 8411.91.10.40 as basic cast-iron turbojet parts.
Cast Iron Gas Turbine Inlet Housing
Rough cast iron inlet manifold for non-aircraft industrial gas turbines, machined solely for gate removal and fixture location in finishing equipment. HTS 8411.91.10.40 applies to such unprepared cast-iron components of turbojets or turbopropellers.
Cast Iron Non-Aircraft Turbine Nozzle Ring
Rough-machined cast iron nozzle guide vane ring for industrial non-aircraft gas turbines, prepared only by cleaning casting flash and risers. Meets HTS 8411.91.10.40 criteria for unfinished cast-iron turbopropeller parts.
Cast Iron Generator Drive Shaft Casting
Basic cast iron shaft blank for coupling turbojets to generators in non-aircraft power plants, with minimal machining for sprue removal. HTS 8411.91.10.40 covers such preparatory cast-iron turbojet parts.