Pull-Tab Aluminum Lid Sheet Stock
Flat aluminum alloy rectangular sheets engineered for easy-open pull-tab can lids, with thickness 0.20-0.30 mm typical for score-line formation. HTS 7606.12.3055 applies as unclad lid stock in the aluminum can stock category. Surface finish optimized for printing and sealing compound adhesion.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If classified as body stock for cans
Can stock subheading splits body vs lid based on manufacturer intent and specs.
If shaped into door or panel blanks
Changes from flat stock to shaped aluminum structures for vehicles/buildings.
If thickness under 0.2 mm (foil range)
Thinner than 0.2 mm shifts to Chapter 76 foil provisions.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include technical datasheets specifying lid-forming parameters; CBP often requests proof distinguishing from body stock
• Label shipments clearly as 'Lid Stock - Not for Body' to prevent commingling errors in warehouses
• Check for minimum order quantities from mills; small lots may face higher scrutiny on alloy certification
Related Products under HTS 7606.12.30.55
Aluminum Beverage Can Lid Stock
Rectangular sheets of aluminum alloy, thickness between 0.2 mm and 6.3 mm, specifically designed for manufacturing pull-tab lids on aluminum beverage cans. Classified under HTS 7606.12.3055 as lid stock due to its precise alloy composition and thickness optimized for lid forming processes. Not clad, ensuring uniform material properties for high-speed production lines.
Easy-Open End Lid Aluminum Stock
Specialized aluminum alloy plates for easy-open can ends, rectangular format with thickness exceeding 0.2 mm but ≤6.3 mm, unclad. Falls under 7606.12.3055 as dedicated lid stock for food/beverage canning. Alloy formulation supports deep drawing and rivet formation without cracking.
Beverage Can End Stock Sheets
Rectangular aluminum alloy sheets, 0.22-0.28 mm thick, for stamping beverage can ends with stay-on-tab mechanisms. Precisely classified as lid stock under HTS 7606.12.3055 due to can stock designation and unclad rectangular form >0.2 mm thick.
Food Can Lid Alloy Plate Stock
Aluminum alloy rectangular plates >0.2 mm thick ≤6.3 mm for sanitary food can lids, unclad construction. HTS 7606.12.3055 lid stock classification reflects its role in two-piece can end production. Enhanced corrosion resistance for acidic food packaging.
Stay-On-Tab Lid Aluminum Sheets
Precision-rolled aluminum alloy sheets for stay-on-tab beverage can lids, rectangular, 0.25 mm nominal thickness, unclad. Classified HTS 7606.12.3055 as specialized lid stock within aluminum can stock provisions.
RPT Stay-On-Tab End Stock
'RPT' (rivet-press-tab) aluminum alloy lid stock sheets, rectangular >0.2mm ≤6.3mm thick, for advanced beverage can ends. Unclad material per HTS 7606.12.3055 lid stock specs supports integral rivet formation.