1070 Aluminum Strip 0.8mm Thick
Narrow rectangular strip of 1070 unalloyed aluminum (99.7% Al), 0.8mm thick, not clad, used in electronics. HTS 7606.11.30 applies as strip is included in plates/sheets/strip >0.2mm, rectangular, not alloyed.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If for alloyed versions
Alloyed strips (e.g., 3003 series) classify under 7606.12.90, different duty structure.
If thickness ≤0.2mm
Thin strips ≤0.2mm are 'wire' per Chapter 76 notes if ≤6mm cross-section.
If table/l kitchen ware blanks
Pre-formed blanks for utensils shift to 7615, end-use based.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Distinguish strip width (<600mm typically) from plate but both under same HTS if specs match
• Require origin certificates for GSP eligibility; unalloyed Al often qualifies for reductions
• Watch for 'not clad' certification; clad strips common in auto use, higher duties
Related Products under HTS 7606.11.30
1060 Aluminum Sheet 1mm Thick
A rectangular sheet of unalloyed 1060 aluminum alloy with 99.6% aluminum content and thickness of 1mm, exceeding 0.2mm, not clad with any other material. It falls under HTS 7606.11.30 as it meets the definition of aluminum, not alloyed, in plate/sheet/strip form with rectangular shape.
1050 Aluminum Plate 3mm Thick
Rectangular plate made from 1050 unalloyed aluminum (99.5% Al), 3mm thick, used for general fabrication, not clad. Classified under 7606.11.30 due to thickness >0.2mm, rectangular shape, and compliance with not alloyed definition.
1100-H14 Aluminum Sheet 0.5mm Thick
Half-hard (H14) 1100 aluminum sheet, rectangular, 0.5mm thick, unalloyed with 99% min Al, not clad, for signage and insulation. Meets HTS 7606.11.30 criteria for thickness, shape, and purity.
Pure Aluminum Building Panel Sheet 2.5mm
Rectangular 99.99% pure aluminum sheet, 2.5mm thick, not alloyed or clad, for architectural panels. Fits HTS 7606.11.30 precisely as unalloyed plate/sheet/strip >0.2mm, rectangular.
1145 Annealed Aluminum Sheet 1.2mm
O-temper 1145 unalloyed aluminum sheet (99.45% Al), rectangular 1.2mm thick, not clad, for packaging. Under HTS 7606.11.30 for pure Al plates/sheets rectangular >0.2mm.
Commercial Pure Aluminum Square Plate 4mm
Square (rectangular incl.) 99.0% commercial pure aluminum plate, 4mm thick, not clad, for machinery bases. HTS 7606.11.30 covers square shapes as rectangular, unalloyed >0.2mm.