Copper Alloy Door Hinge Casting
A cast copper-zinc alloy hinge used for doors, produced through die-casting without any further machining or finishing. It falls under HTS 7419.20.00 as a cast article of copper alloy that is not further worked beyond the initial forming process. This classification applies to unfinished castings intended for assembly into final hardware products.
Import Duty Rates by Country of Origin
| Origin Country | MFN Rate | Ch.99 Surcharges | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | +35.0% | 35% |
| 🇲🇽Mexico | Free | +10.0% | 10% |
| 🇨🇦Canada | Free | +10.0% | 10% |
| 🇩🇪Germany | Free | +10.0% | 10% |
| 🇯🇵Japan | Free | +10.0% | 10% |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If machined or polished after casting
Further worked mountings, fittings and similar articles of base metal fall under Chapter 83 when they undergo additional processing beyond casting.
If made of refined copper without alloying elements
Articles of refined copper (not alloys) are classified separately from copper alloy articles.
If imported as flywheel or pulley castings
Specific transmission component castings have dedicated classifications in Chapter 84.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify alloy composition meets copper-zinc base alloy definitions to avoid reclassification; provide foundry casting certificates; watch for over 3% tin content which shifts to bronze category
Related Products under HTS 7419.20.00
Stamped Copper Bracket for Machinery
A stamped brass bracket designed to support machinery components, created by precision stamping from copper-zinc sheet without subsequent bending or finishing. Classified under HTS 7419.20.00 for stamped copper articles not further worked, distinguishing it from fabricated parts.
Forged Copper Faucet Valve Body
Forged copper alloy body for plumbing valves, drop-forged and left in rough form without machining internal threads or surfaces. This product is covered by HTS 7419.20.00 as a forged copper article not further worked, prior to final assembly.
Cast Bronze Marine Propeller Hub
Cast copper-tin bronze hub for marine propellers, sand-cast without machining or balancing. Falls under HTS 7419.20.00 as a cast article of copper alloy (bronze per subheading note b) not further worked.
Stamped Copper Electrical Terminal
Precision stamped copper-zinc terminals for wiring harnesses, produced by progressive die stamping without forming or plating. HTS 7419.20.00 covers such stamped copper alloy articles prior to further fabrication.
Molded Copper Heat Sink Base
Die-molded copper alloy base plate for electronic heat sinks, formed without fin machining or surface finishing. Classified in HTS 7419.20.00 for molded copper articles not further worked.
Forged Brass Lock Cylinder Blank
Forged brass blanks for pin tumbler lock cylinders, hot-forged without keyway cutting or finishing. HTS 7419.20.00 applies to such forged copper alloy security hardware components.