Common Steel Framing Nails
Smooth shank steel nails with diamond point and flat head for general framing in construction. One-piece iron or steel construction fits HTS 7317.00.65 as 'other' nails of one piece. Formed from wire per chapter notes, no cross-section over 16mm.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If ring shank or barbed
Shank features like ring or barb trigger specific subheading over generic 'other'.
If thumb tacks or drawing pins
Small-headed tacks for pinning shift to earlier provisions.
If with decorative copper-plated heads
Copper-headed articles specifically excluded to heading 8305.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Provide detailed invoices specifying shank type (smooth) and gauge to match 'other' category
• Anti-dumping duties may apply from certain origins; check Commerce scope rulings
Related Products under HTS 7317.00.65
Vinyl Coated Steel Finish Nails
Slim steel nails with vinyl coating, brad head, and chisel point for trim and finish carpentry. Classified in 7317.00.65 as one-piece steel nails without copper heads. Coating doesn't alter one-piece status; wire-formed under chapter definition.
Spiral Shank Steel Nails
Steel nails with spiral thread shank for maximum withdrawal resistance in softwoods. HTS 7317.00.65 as one-piece 'other' nails, spiral not equating to 'twisted' in notes. Wire-formed product.
Cut Round Steel Nails
Traditional cut steel nails with square shank from sheet metal, square head. Unlike wire nails, but still one-piece for HTS 7317.00.65 'other'. Chapter notes accommodate cut forms.
Ceiling Clip Steel Nails
Short steel nails with clip head for suspended ceiling grids. One-piece pins/nails under 7317.00.65 excluding staples. Short length fits wire cross-section.
Lath Steel Nails
Diamond point steel nails for plaster lath attachment in walls. One-piece construction HTS 7317.00.65. Traditional building material.
Underlayment Steel Nails
Galvanized steel nails with large head for roofing underlayment. One-piece 7317.00.65 'other' nails. Head prevents pull-through.