3-Inch 15 Gauge Angled Plastic Strip Nails
Heavy-duty 15-gauge round wire nails in 3-inch length, collated at 21 degrees in plastic strips for pneumatic nailers. Fits HTS 7317.00.55.07 as other plastic strip collated nails from one-piece round wire. Suited for subflooring and decking applications.
Import Duty Rates by Country of Origin
| Origin Country | MFN Rate | Ch.99 Surcharges | Total Effective Rate |
|---|---|---|---|
| šØš³China | Free | +35.0% | 35% |
| š²š½Mexico | Free | +10.0% | 10% |
| šØš¦Canada | Free | +10.0% | 10% |
| š©šŖGermany | Free | +10.0% | 10% |
| šÆšµJapan | Free | +10.0% | 10% |
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If with specific protective finish
Certain finishes like hot-dip galvanizing are carved out into 7317.00.55.05.
If collated but not one-piece construction
Multi-piece assembly excludes from one-piece round wire subheading.
If considered pins or tacks for upholstery
Smaller upholstery pins may shift to 7319.40 if not meeting nail dimensions.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
ā¢ Specify collation angle (e.g
ā¢ 21Ā°) and strip material to differentiate from paper collated
ā¢ Check for country-of-melt origin labeling to comply with steel import regulations
Related Products under HTS 7317.00.55.07
1-1/4 Inch 18 Gauge Finish Nails in Plastic Strip
Fine 18-gauge round steel wire nails, 1-1/4 inches long, held in plastic collation strips for finish nail guns. HTS 7317.00.55.07 applies to these other assembled plastic strip collated nails of one-piece construction. Used for cabinetry and molding installation.
Plastic Strip Collated 16 Gauge Brad Nails
These are one-piece construction nails made from round steel wire, collated in a plastic strip for use in pneumatic brad nailers. They fall under HTS 7317.00.55.07 as collated nails of round wire assembled in a plastic strip, other than those for specific finishes. Ideal for finish carpentry and trim work.
2-Inch Plastic Strip Framing Nails 16D
Round wire steel nails measuring 2 inches long, collated in plastic strips for 21-degree plastic strip nailers used in framing. Classified in HTS 7317.00.55.07 for other collated nails of one-piece round wire construction in plastic strips. Commonly used in residential construction for wall framing.
2-1/2 Inch 16 Gauge Siding Nails Plastic Collated
16-gauge round steel wire nails designed for siding, 2-1/2 inches long, in plastic strip collation for coil or strip nailers. HTS 7317.00.55.07 covers these as other assembled plastic strip collated nails. Ring shank provides superior holding power in exterior applications.