Alloy Steel Butt Weld Wye 6 Inch
Wye fitting (Y-shaped) from non-stainless alloy steel, 150 mm ID, butt weld for diverging flows. Under HTS 7307.93.60.00 as alloy butt fitting <360 mm. Used in drainage and ventilation systems.
Import Duty Rates by Country of Origin
| Origin Country | MFN Rate | Ch.99 Surcharges | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | 5.5% | +35.0% | 40.5% |
| 🇲🇽Mexico | 5.5% | +10.0% | 15.5% |
| 🇨🇦Canada | 5.5% | +10.0% | 15.5% |
| 🇩🇪Germany | 5.5% | +10.0% | 15.5% |
| 🇯🇵Japan | 5.5% | +10.0% | 15.5% |
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If fabricated from plate, not seamless
Plate-welded fittings are other categories.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Describe branch angle precisely (e.g
• 45 deg) in manifests
• Avoid bulk tube confusion; highlight formed branches
Related Products under HTS 7307.93.60.00
Alloy Steel Butt Weld Tee 6 Inch
A straight tee fitting of non-stainless alloy steel with 150 mm inside diameter, for butt welding to branch pipes in high-pressure systems. Classified under HTS 7307.93.60.00 due to its alloy steel material and butt-weld design with ID <360 mm. Ideal for petrochemical processing plants.
Alloy Steel Butt Weld Equal Tee 2 Inch
Equal branch tee fitting from non-stainless alloy steel, 50 mm ID all ends, butt weld type. Under HTS 7307.93.60.00 for small-diameter alloy butt fittings. Common in instrumentation and small bore piping.
Alloy Steel Butt Weld Elbow 4 Inch
A 90-degree elbow fitting made from alloy steel (non-stainless) with an inside diameter of 100 mm, designed for butt welding to connect pipes at angles. It falls under HTS 7307.93.60.00 as a butt welding fitting of alloy steel, inside diameter less than 360 mm. Commonly used in oil and gas pipelines for directional changes.
Alloy Steel Butt Weld Reducer 8 Inch to 4 Inch
Concentric reducer fitting from non-stainless alloy steel, reducing from 200 mm to 100 mm ID, for butt welding in pipe transitions. Meets HTS 7307.93.60.00 as a butt welding fitting of alloy steel under 360 mm ID. Used in power generation and refineries.
Alloy Steel Butt Weld Cross 3 Inch
Four-way cross fitting of alloy steel (except stainless), 75 mm ID, designed for butt welding in multi-branch piping. Falls under HTS 7307.93.60.00 for its material, butt-weld construction, and small diameter. Applied in complex industrial flow systems.
Alloy Steel Butt Weld Cap 10 Inch
End cap fitting for butt welding, made of non-stainless alloy steel with 250 mm ID, to seal pipe ends. Classified in HTS 7307.93.60.00 as alloy steel butt welding fitting <360 mm ID. Standard in construction and maintenance of pipelines.