Non-Alloy Steel Pipe Hollows for Redrawing 50mm OD
Cylindrical welded hollow profiles of non-alloy steel, 50mm outside diameter and wall thickness ≥1.65mm, produced for further redrawing into precision tubes used in automotive or machinery. Classified under HTS 7306.30.50.35 as 'tube and pipe hollows for redrawing' within welded, circular, other tubes. Meets chapter definition for iron/steel hollow products not exceeding specified dimensions.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If outside diameter exceeds 114.3 mm
Larger diameter hollows fall outside this specific OD limit, moving to adjacent 'other' welded tube subheadings.
If non-circular cross-section (e.g., square hollows)
Only circular cross-sections qualify for 7306.30; other profiles go to 7306.90 for different shapes.
If imported in semi-finished flat-rolled form before welding
Pre-welded flat products classify under Chapter 72 as semi-finished steel, not welded tubes in Chapter 73.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Label shipments clearly as 'hollows for redrawing' with buyer contracts specifying end-processing to prevent misclassification as finished goods
• Conduct material analysis to confirm non-alloy status, as alloy traces could trigger reclassification and higher duties
• Watch for overlength shipments; ensure OD ≤114.3mm to stay in this subheading and avoid broader 'other' categories
Related Products under HTS 7306.30.50.35
Welded Steel Tube Hollows for Redrawing 25mm OD
These are welded, circular cross-section steel tube hollows of non-alloy steel with an outside diameter of 25mm and wall thickness over 1.65mm, specifically designed as intermediates for redrawing into thinner-walled tubes. They fall under HTS 7306.30.50.35 due to their classification as 'tube and pipe hollows for redrawing' in the other welded category. This distinguishes them from finished tubes or those under 1.65mm wall thickness.
Heavy Wall Steel Hollows for Pipe Redrawing 90mm
90mm OD welded steel hollows with ≥1.65mm walls, non-alloy, for redrawing into structural pipes. Under HTS 7306.30.50.35 as tube/pipe hollows for redrawing, excluding finer wire products. Designed for industrial redraw mills.
Industrial Redrawing Hollow Profiles 60mm OD
Welded non-alloy steel hollow profiles, 60mm OD, thick wall, for redrawing into hydraulic lines. HTS 7306.30.50.35 for other circular welded hollows designated for redrawing.
Carbon Steel Redraw Hollows 70mm OD
70mm OD carbon (non-alloy) steel welded hollows ≥1.65mm wall for pipe redrawing. HTS 7306.30.50.35 exact match.
Welded Hollow Pipe Stock 110mm OD Redrawing
110mm OD thick-wall welded pipe hollows for redrawing into line pipe. 7306.30.50.35 classification.
Welded Iron Tube Hollows for Redrawing 80mm OD
Heavy-walled (≥1.65mm) welded tube hollows of iron or low-carbon steel, 80mm OD, intended for redrawing into thinner pipes for construction or fluid transport. HTS 7306.30.50.35 applies to these open-seamed or welded hollow profiles explicitly noted for redrawing, distinguishing from standard pipes. Conforms to chapter notes on iron/steel hollow products.