Alloy Steel Equal Leg Angle 40x40x4mm Hot-Rolled
Equal leg angle profile from hot-rolled alloy steel, 40 mm leg length and 4 mm thickness, ideal for reinforcement in automotive chassis components. Fits HTS 7228.70.30.60 for alloy steel angles with cross-section under 76 mm, hot-rolled without advanced processing. Excludes high-strength or tool steel per chapter notes.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If not alloy steel but other steel types
Non-alloy steel versions classify under 7228.60 for similar hot-rolled angles and shapes.
If concrete reinforcing with ribs or deformations
Deformed bars for concrete per US Note 72(c) go to specific reinforcing bar headings.
If shapes or sections rather than strict angles
Non-angle shapes like channels or tees in same dimension range use the prior subheading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Ensure no 'further worked' treatments like coating or polishing per Chapter 72 note, or it shifts to cold-formed headings
• Verify not qualifying as high-strength steel (yield point specs in US Note 72(a)) to prevent misclassification
• Accurate gauge and dimension labeling avoids customs holds; use caliper measurements in documentation
Related Products under HTS 7228.70.30.60
Hot-Rolled L-Section Alloy Steel Angle 50x50x5mm
Hot-rolled L-shaped angle bar made from alloy steel with a maximum cross-sectional dimension of 50 mm, used in structural framing for machinery and equipment. Classified under HTS 7228.70.30.60 as hot-rolled angles of alloy steel, not drilled, punched, or further advanced, with cross-section under 76 mm. Meets chapter definitions for alloy steel bars and rods in angle shapes.
Structural Alloy Steel Angle Bar 60x60x6mm
Hot-rolled unequal angle bar of alloy steel for building frameworks and supports, max cross-section 60 mm. Directly matches HTS 7228.70.30.60 criteria for hot-rolled alloy steel angles under 76 mm, not drilled or punched. Standard structural grade excluding specialized steels like tool or heat-resisting per chapter notes.
Hot-Rolled Alloy L-Angle 30x30x3mm
Compact L-angle from hot-rolled alloy steel, 30 mm cross-dimension, used in furniture framing and light machinery. HTS 7228.70.30.60 applies to such small-section hot-rolled alloy angles not advanced beyond rolling. Distinguished from cold-formed by production method and surface condition.
Alloy Steel Angle Profile 45x45x5mm Hot-Rolled
45 mm equal angle hot-rolled from alloy steel for general fabrication and repair work. Classed in HTS 7228.70.30.60 as other hot-rolled angles/shapes of alloy steel under 76 mm max dimension, excluding hollow drill types. No special steel qualifications like chipper knife or razor blade steel.