Hot-Rolled Alloy Steel L-Angle 100x100x10mm
A hot-rolled L-shaped angle bar made from alloy steel with equal 100mm legs and 10mm thickness, featuring a maximum cross-sectional dimension over 76mm. Classified under HTS 7228.70.30.20 as hot-rolled angles of other alloy steel, not drilled, punched, or further advanced beyond rolling. Used in structural frameworks and machinery supports.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If unequal leg angles
Unequal angles fall under separate statistical suffix 3045 within the same heading for hot-rolled alloy steel shapes.
If made of non-alloy steel
Non-alloy steel bars and rods, including angles, are classified in heading 7214, not Chapter 72 alloy steel provisions.
If fabricated into structural assemblies
Fabricated steel structures or assemblies exceeding simple bars/sections move to heading 7308 for built-up products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide mill test certificates confirming alloy steel composition and hot-rolled condition without drilling or punching
• Measure maximum cross-sectional dimension accurately; must exceed 76mm to qualify under this subheading
• Avoid common pitfalls like misclassifying as cold-formed (7301) or tool steel grades requiring special certification
Related Products under HTS 7228.70.30.20
Alloy Steel Angle Bar 125x125x12mm Hot-Rolled
Equal-leg hot-rolled angle section from other alloy steel, 125mm x 125mm with 12mm wall thickness, max dimension 125mm >76mm. Fits HTS 7228.70.30.20 for hot-rolled, non-drilled alloy steel angles used in construction bracing and equipment frames.
Structural Alloy L-Section 150x150x15mm
Hot-rolled L-angle structural section of other alloy steel, 150mm legs x 15mm thick, cross-section 150mm exceeding 76mm limit. HTS 7228.70.30.20 applies to these simple hot-rolled shapes without drilling for bridge and building frameworks.
Hot-Rolled Alloy Steel Unequal Angle 200x100x16mm
Unequal leg hot-rolled angle bar of alloy steel, 200mm x 100mm x 16mm thick, max dimension 200mm >76mm. Covered by HTS 7228.70.30.20 as other hot-rolled angles/shapes of alloy steel for heavy machinery and shipbuilding.
Alloy Steel Framework Angle 80x80x8mm
Hot-rolled equal angle profile from other alloy steel, 80x80x8mm with 80mm max dimension qualifying >76mm. HTS 7228.70.30.20 for non-advanced alloy angles used in industrial frameworks and racking systems.
Heavy Duty Alloy L-Bar 100x75x12mm Hot-Rolled
Hot-rolled unequal L-angle bar of alloy steel, 100x75mm legs x12mm, max 100mm cross-section. Meets HTS 7228.70.30.20 criteria for hot-rolled alloy angles >76mm used in heavy equipment fabrication.
Construction Grade Alloy Angle 90x90x10mm
Equal angle hot-rolled from other alloy steel for construction, 90mm x90mm x10mm thick, 90mm dimension. HTS 7228.70.30.20 covers these non-punched angles for building lintels and supports.