Cold-Drawn 15-5PH Stainless Alloy Bar
15-5PH martensitic PH stainless steel flat bar, cold-drawn 50x10 mm cross-section for pump shafts. HTS 7228.50.5015 applies to cold-formed alloy steel shapes <76 mm. Improved corrosion resistance over 17-4PH.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If stainless bar shapes
Stainless-specific headings take precedence over generic alloy.
If high-silicon electrical steel
Special electrical alloy steels have dedicated provisions.
If fabricated into shafting
Finished articles move to Chapter 73 semifinished/completed goods.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Measure rectangular cross-section at maximum dimension for 76 mm limit
• Include corrosion test results if marketed for marine applications
• Distinguish from wire rod (smaller diameter, continuous cast)
Related Products under HTS 7228.50.50.15
Cold-Formed 4140 Alloy Steel Round Bar
A 4140 chromium-molybdenum alloy steel bar, cold-formed with a diameter of 25 mm, used in mechanical engineering for shafts and gears. Classified under HTS 7228.50.5015 as other bars and rods of alloy steel, not further worked than cold-formed or cold-finished, with cross-section less than 76 mm. Meets alloy steel definition due to chromium and molybdenum content.
Cold-Finished 4340 Alloy Steel Hexagonal Bar
High-strength 4340 nickel-chromium-molybdenum steel hexagonal bar, cold-finished to 40 mm across flats, for aerospace fasteners. Falls under HTS 7228.50.5015 as cold-finished alloy steel bars with cross-section under 76 mm, not further worked beyond cold-finishing. Alloy status from Ni-Cr-Mo elements exceeding Chapter 72 thresholds.
Cold-Drawn 8620 Alloy Steel Square Bar
8620 carburizing alloy steel square bar, cold-drawn to 50 mm sides, for gear manufacturing. HTS 7228.50.5015 applies to cold-formed alloy steel bars under 76 mm cross-section, not further worked. Case-hardening grade with controlled carbon, nickel, chromium, molybdenum.
Cold-Formed 300M Alloy Steel Round Bar
Ultra-high strength 300M vacuum arc remelted alloy steel bar, cold-formed 35 mm diameter for aircraft landing gear. Under HTS 7228.50.5015 as other cold-formed alloy steel rods <76 mm, qualifying as high-strength per note (a). Modified 4340 with higher Si, V for superior fatigue resistance.
Cold-Finished 17-4PH Stainless Alloy Steel Bar
Precipitation hardening 17-4PH stainless steel round bar, cold-finished to 60 mm diameter for valve stems. HTS 7228.50.5015 covers cold-finished other alloy steel bars <76 mm cross-section. Stainless alloy steel with 17% Cr, 4% Ni, copper precipitation hardening.
Cold-Drawn E4340 Alloy Steel Rod
Electroslag remelted E4340 alloy steel rod, cold-drawn 20 mm diameter for high-stress bolts. Classified HTS 7228.50.5015 as cold-formed alloy steel rods <76 mm, not further worked. Enhanced cleanliness version of 4340 for critical applications.