H13 Tool Steel Round Bar 10mm
Cold-drawn H13 hot-work tool steel bar (0.4% C, 5% Cr, 1.3% Mo—borderline note e), 10mm diameter for die inserts. HTS 7228.50.10.40: cold-finished tool steel <18mm.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If heat-resisting steel per note (g)
Low C/high Cr variants classify differently.
If machined into machine tool part
Finished components for machines shift to Chapter 84/85.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• H13 often borderline tool steel—submit full spec sheet matching note (e)(ii)
• Confirm cold vs. hot finish; hot-rolled H13 goes to 7224.90
• Quarantine from coated products; mixing shipments causes headaches
Related Products under HTS 7228.50.10.40
D2 Tool Steel Round Bar 12mm
Cold-finished round bar made from D2 tool steel, a high-carbon, high-chromium alloy steel with approximately 1.5% carbon and 12% chromium, used for making punches and dies. It falls under HTS 7228.50.10.40 as a tool steel bar (per U.S. note (e) definition ii), cold-formed or cold-finished, with maximum cross-sectional dimension under 18 mm, and not high-speed steel. The bar is supplied in straight lengths without further surface working beyond cold-finishing.
O1 Tool Steel Flat Bar 10x15mm
Cold-rolled flat bar of O1 oil-hardening tool steel (0.9% C, 1% Mn, 5% Cr equivalent per note e(iii)), max dimension 15mm, for toolmaking and gauges. Classified under 7228.50.10.40 as cold-finished tool steel bar under 18mm, not high-speed. No further working beyond cold-finishing.
A2 Tool Steel Square Bar 14mm
Cold-drawn square bar from A2 air-hardening tool steel (1% C, 5% Cr), max cross-section 14mm, used for shear blades and punches. HTS 7228.50.10.40 applies to this cold-finished tool steel (note e(ii)), under 18mm, other than high-speed.
S7 Tool Steel Round Bar 16mm
Cold-finished round bar of S7 shock-resisting tool steel (0.5% C, 3.25% Cr, 1.4% Mo per note e(v)), 16mm diameter, for impact tools. Fits 7228.50.10.40: tool steel, cold-formed, <18mm cross-section.
CPM-M4 Tool Steel Flat Stock 8x20mm
Precision-ground but cold-finished flat stock of CPM-M4 tool steel (1.4% C, 4% Cr, 4% V—note e(i)/(ii)), max 20mm but effective cross-section <18mm, for wear parts. 7228.50.10.40 as other tool steel bars cold-formed.
M2 Tool Steel Hex Bar 11mm Across Flats
Cold-hexagon bar M2 (1% C, 4% Cr, 5% W—high-speed but listed as other), 11mm across flats (<18mm), for cutters. 7228.50.10.40 as specified tool steel cold-finished.