Hot-Rolled EN 10025 S355J2 Alloy Steel Plate
Structural alloy steel plate grade S355J2 per EN 10025, hot-rolled 4.2 mm thickness, 1100 mm wide, not coiled. HTS 7225.40.70.00 for other alloy flat-rolled products ≥600 mm wide, hot-rolled <4.75 mm thick.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If carbon steel not alloy
Must meet alloy steel minimum element requirements; otherwise carbon steel under 7211.
If further worked than hot-rolled
Any surface treatment beyond hot-rolling (polishing, coating) classified in Chapter 72 heading 7226.
If electrical alloy steel
Silicon-electrical steel alloys have dedicated provisions separate from 'other' alloys.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include EN 10204 material certificates type 3.1 for alloy verification
• Confirm not 'high-strength steel' per note (a) to avoid special provisions
• Separate shipments by exact thickness to prevent averaging issues
Related Products under HTS 7225.40.70.00
Hot-Rolled AISI 4140 Alloy Steel Plate
Hot-rolled flat-rolled product of chromium-molybdenum alloy steel (AISI 4140) with thickness 4 mm and width 1200 mm, not in coils and not further worked beyond hot-rolling. Classified under HTS 7225.40.70.00 as alloy steel (not stainless), width over 600 mm, thickness under 4.75 mm, hot-rolled not in coils, other category.
Hot-Rolled AISI 4340 Low Alloy Steel Sheet
Hot-rolled sheet of nickel-chromium-molybdenum steel (AISI 4340), 3.5 mm thick, 900 mm wide, supplied flat not in coils. Falls under HTS 7225.40.70.00 for other alloy steel, hot-rolled not further worked, width ≥600 mm, thickness <4.75 mm.
Hot-Rolled ASTM A514 Grade B High-Strength Alloy Steel Plate
High-strength low-alloy steel plate per ASTM A514 Grade B spec, hot-rolled 3.2 mm thick, 1500 mm wide, not in coils. HTS 7225.40.70.00 applies as other hot-rolled alloy steel under 4.75 mm thickness, width over 600 mm.
Hot-Rolled AISI 8620 Case Hardening Alloy Steel Sheet
Nickel-chromium-molybdenum alloy steel (AISI 8620) hot-rolled into 2.8 mm sheets, 800 mm width, flat packed. Classified HTS 7225.40.70.00: alloy steel flat-rolled ≥600 mm wide, <4.75 mm thick, hot-rolled not further worked.