O1 Tool Steel Hot-Rolled Coil
O1 oil-hardening tool steel flat-rolled product, 2.5 mm thick, 1000 mm wide, hot-rolled in coils without further processing. Fits HTS 7225.30.51 due to tool steel specs with 0.9% carbon and 1% manganese per US Note 72(e).
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If cold-rolled after hot-rolling
Cold-rolled tool steel (further worked) classified separately from hot-rolled.
If primarily carbon steel rather than alloy
Low alloy content may classify under flat-rolled carbon steel headings.
If for non-coil hot-rolled form
Tool steel hot-rolled plates/sheets not in coils go to thickness-based non-coil codes.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Declare exact chemical analysis matching US tool steel note; mismatches lead to 7225.99 reclassification
• Verify width exceeds 600 mm and coil packaging intact to qualify for this specific subheading
• Document hot-rolling only; any cold-rolling shifts to 7225.40 series
Related Products under HTS 7225.30.51
D2 Tool Steel Hot-Rolled Coil
Flat-rolled D2 tool steel coil, 3 mm thick and 800 mm wide, not further worked beyond hot-rolling. Classified under HTS 7225.30.51 as it meets tool steel definition with over 1.2% carbon and over 10.5% chromium, in coils under 4.75 mm thickness.
A2 Tool Steel Hot-Rolled Coil Sheet
A2 air-hardening tool steel coil, 3.8 mm thickness, 700 mm width, solely hot-rolled. Under HTS 7225.30.51 as alloy tool steel with 0.3-1.2% carbon and 5% chromium meeting Chapter 72 note (e)(ii).
S7 Tool Steel Hot-Rolled Coil
S7 shock-resisting tool steel hot-rolled coil, 4 mm thick, 900 mm wide, no further work. HTS 7225.30.51 applies for tool steel with 0.5% carbon and 3.5% molybdenum per US note 72(e)(v).
M2 High-Speed Tool Steel Coil
M2 high-speed steel flat-rolled hot-rolled coil, 3.2 mm thick, 650 mm wide. Meets HTS 7225.30.51 tool steel criteria with tungsten/molybdenum content per US Chapter 72 definitions.
H13 Tool Steel Hot-Rolled Coil
H13 hot work tool steel coil stock, 2.8 mm gauge, 1200 mm width, hot-rolled only. Classified HTS 7225.30.51 as tool steel with defined chromium/carbon per note 72(e).