430 Stainless Steel Hexagonal Rod
Hexagonal rod in 430 stainless steel grade with <0.5% nickel content and cross-sections exceeding 152.4 mm, used in architectural trim. HTS 7222.30.00.82 covers this as 'other bars and rods' of low-nickel stainless, excluding angles/shapes/sections.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If not stainless (lower chromium)
Non-stainless hot-rolled bars/rods of iron/non-alloy steel fall under Chapter 72 earlier headings.
If alloy but delivered in coil form
Coiled delivery form for other alloy steel bars shifts to Chapter 72 delivery-form headings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Submit heat analysis reports confirming chromium >10.5% for stainless status and nickel <8%
• Label shipments clearly distinguishing bars/rods from angles/shapes to prevent CBP reclassification
• Check for Section 232 tariffs on steel; low-nickel grades may qualify for exemptions with proper docs
Related Products under HTS 7222.30.00.82
Duplex 2205 Stainless Round Bar (Low Ni Variant)
Special low-nickel duplex 2205 variant (~5% Ni) round bar, 180 mm diameter for offshore platforms. Still <8% Ni threshold for HTS 7222.30.00.82 classification.
AISI 304L Stainless Steel Round Bar
A round bar made from AISI 304L stainless steel with less than 8% nickel content, featuring a maximum cross-sectional dimension exceeding 152.4 mm. Classified under HTS 7222.30.00.82 as other bars and rods of stainless steel, not angles/shapes/sections, due to its circular cross-section and alloy composition meeting the nickel limit. Commonly used in structural applications requiring corrosion resistance.
409 Stainless Steel Square Bar
Square bar of grade 409 ferritic stainless steel containing under 8% nickel (typically <1%), with cross-sectional dimensions up to 200 mm. Fits HTS 7222.30.00.82 as other stainless steel bars (not angles/shapes), distinguished by large size and low-nickel composition for automotive exhaust applications.
17-4 PH Stainless Steel Flat Bar
Precipitation-hardening 17-4 PH flat bar with approximately 4% nickel content and thickness/width exceeding 152.4 mm max dimension. Classified in HTS 7222.30.00.82 for low-nickel stainless bars used in aerospace components.
439 Stainless Steel Round Rod
Grade 439 ferritic stainless round rod, nickel-free (<0.5%), with diameter >152.4 mm for exhaust system fabrication. HTS 7222.30.00.82 applies to these large, low-nickel stainless bars/rods.
AISI 410 Stainless Steel Bar Stock
Martensitic AISI 410 stainless bar stock with minimal nickel (<1%) and large 6-inch (152.4+ mm) cross-section for valve shafts. Falls under HTS 7222.30.00.82 as other low-nickel stainless bars.