430 Ferritic Stainless Steel Hot-Rolled Channel Section
2x0.75x0.125 inch channel section from 430 SS (<0.5% Ni), hot-rolled for conveyor frames. Remains rough hot-rolled surface, not further worked. Low Ni content fits precise subheading.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If imported as specific shapes
Dedicated shapes/sections subheading may apply over generic 'other'.
If concrete reinforcing type
Ribbed/grooved bars per US Note (c) classify under 7214.20.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Profile drawings required to confirm 'other bars/rods' vs shapes
• Ni content lab reports mandatory at entry
• Separate from universal mill plate specs in notes
Related Products under HTS 7222.19.00.52
409 Hot-Rolled Stainless Steel Billet Stock
4x4 inch square billet of 409 SS (<1% Ni), hot-rolled for automotive exhaust feedstock. Minimal working beyond rolling, treated as rod/bar stock. Low Ni ferritic composition matches HTS.
Hot-Rolled 304 Stainless Steel Round Bar
A 1-inch diameter round bar made from 304 grade stainless steel, containing approximately 8-10% nickel but certified under this subheading for specific low-nickel batch variants under 8%. It is hot-rolled and not further worked, used in structural applications like machinery frames. Falls under HTS 7222.19.0052 due to its hot-rolled form and nickel content specification.
Hot-Extruded 430 Stainless Steel Flat Bar
A 2x0.5 inch flat bar of 430 ferritic stainless steel with less than 0.5% nickel, hot-extruded for use in automotive trim and appliances. Not further worked beyond extrusion, fitting the 'other bars and rods' category. Classified here for low nickel and hot-forming process.
Hot-Drawn 409 Stainless Steel Square Rod
Half-inch square rod from 409 grade stainless steel (under 1% nickel), hot-drawn for exhaust system components and muffler parts. Remains in hot-worked state without polishing or coating. Meets HTS criteria for other stainless bars with low nickel content.
Hot-Rolled 410 Stainless Steel Hexagonal Bar
3/4-inch hexagonal bar of 410 martensitic stainless steel (<0.5% nickel), hot-rolled for pump shafts and valve stems. No further surface treatments applied, qualifying as 'not further worked'. Low nickel content places it in this specific subheading.
Extruded 439 Stainless Steel Angle Bar
1x1x1/8 inch angle bar from 439 ferritic stainless steel (<1% Ni), hot-extruded for architectural framing. Not further worked beyond extrusion process. Fits 'other' category with nickel under 8% threshold.