Cold-Rolled 304 Stainless Steel Sheet 0.8mm Thick
Flat-rolled 304 stainless steel sheet, cold-rolled to 0.8 mm thickness and 800 mm width, not in coils and not further worked beyond cold-reduction. Classified under HTS 7219.34.0050 due to its stainless steel composition, width over 600 mm, thickness between 0.5-1 mm, and lack of additional surface treatments like polishing or coating.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness under 0.5 mm
Thinner cold-rolled stainless sheets shift to the subheading for <0.5 mm thickness within the same cold-rolled, not further worked category.
If width under 600 mm
Narrower stainless steel strip (under 600 mm) falls under Chapter 72 heading 7220 for flat-rolled products of narrower width.
If in coils
Same spec but coiled form is classified separately under the 'in coils' subheading to distinguish packaging state.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Verify exact thickness and width measurements at entry to confirm 0.5-1mm range and >600mm width for proper 7219.34.0050 classification
• Provide mill test certificate confirming stainless steel composition and cold-rolled status without further working to avoid reclassification
• Watch for rust or discoloration; no duty allowance per Chapter 72 notes, so inspect shipments pre-entry
Related Products under HTS 7219.34.00.50
316L Cold-Rolled Stainless Steel Panel 0.9mm Thick
Cold-rolled 316L austenitic stainless steel panel at 0.9 mm thickness, 700 mm width, not coiled and free of further surface treatments. HTS 7219.34.0050 applies to this exact spec of stainless flat-rolled product, cold-reduced only.
Cold-Rolled 201 Stainless Steel Sheet 0.6mm
0.6 mm cold-reduced 201 stainless steel sheet, 900 mm wide, flat packed not in coils, not further worked. Precisely matches HTS 7219.34.0050 for stainless steel sheets in this thickness range and form.
0.75mm 304 Cold-Reduced Stainless Steel Blank
Rectangular blanks cut from 0.75 mm thick 304 cold-rolled stainless steel, 650 mm wide, not in coils or further worked beyond reduction. HTS 7219.34.0050 covers these dimensional stainless flat products before additional processing.
Cold-Rolled Duplex 2205 Stainless Sheet 1mm
1 mm thick duplex 2205 stainless steel sheet cold-rolled to specification, 1200 mm width, supplied flat without coils or further treatments. Meets all criteria for HTS 7219.34.0050 stainless steel classification.
409 Cold-Rolled Stainless Steel Sheet 0.55mm Thick
Automotive-grade 409 ferritic stainless sheet, cold-rolled to 0.55 mm x 750 mm wide, not coiled, not further worked. HTS 7219.34.0050 exactly describes this stainless flat-rolled product form.
Cold-Rolled 310 Stainless Steel Sheet 0.65mm
High-temperature 310 stainless steel cold-rolled sheet measuring 0.65 mm thick by 850 mm wide, flat not coiled, without further working. Classifies under HTS 7219.34.0050 for stainless cold-reduced sheets.