Duplex 2205 Stainless Cold-Rolled Plate
Duplex 2205 (22% Cr, 5-6% Ni) cold-rolled plate, 1.6 mm thick, 700 mm wide, not further worked beyond cold-reduction and not coiled, fitting HTS 7219.33.0070 nickel range for stainless sheets.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If silicon-electrical steel composition
Specific alloying elements may trigger alternative alloy steel classifications.
If painted surface finish
Painting constitutes further working, moving to painted flat-rolled products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Duplex structure doesn't change HTS but document ferrite/austenite balance; no duty reduction for pre-entry rust per US note; measure thickness uniformly across sheet
Related Products under HTS 7219.33.00.70
TP304 Cold-Rolled Stainless Steel for Piping
TP304 grade cold-rolled sheet specifically for pipe manufacturing, 8-10.5% nickel, 1.9 mm thick x 950 mm wide, not coiled, HTS 7219.33.0070 as cold-reduced stainless flat product.
AISI 304 Cold-Rolled Stainless Steel Sheet
Flat-rolled stainless steel sheet classified under HTS 7219.33.0070, with 18% chromium and 8-10.5% nickel content, cold-rolled to a thickness of 1.5 mm and width over 600 mm, not in coils. This meets the criteria for not further worked than cold-rolled products containing more than 0.5% but less than 24% nickel by weight.
300 Series Nickel-Alloy Cold-Reduced Steel Plate
Cold-reduced stainless steel plate with 10-12% nickel, 1.8 mm thick, 1000 mm wide, flat-rolled and not in coils, fitting HTS 7219.33.0070 for products not further worked than cold-rolled with nickel between 0.5-24%. Used in chemical processing equipment.
17-7PH Precipitation Hardening Stainless Sheet
17-7PH stainless steel sheet, cold-rolled to 2 mm thickness, 750 mm width, containing ~7.5-7.7% nickel, not coiled and not further worked, precisely matching HTS 7219.33.0070 criteria for nickel-alloyed cold-rolled stainless over 1mm thick.
321 Austenitic Stainless Cold-Rolled Sheet
Type 321 stainless steel cold-rolled sheet with 9-12% nickel and titanium stabilization, 2.5 mm thick, 1200 mm wide, not in coils, classified in HTS 7219.33.0070 for cold-reduced stainless with specified nickel range.
310S Heat-Resistant Stainless Steel Panel
310S cold-rolled stainless panel with 19-22% nickel for high-temperature use, 1.2 mm thick, 800 mm wide, flat and not coiled, falling under HTS 7219.33.0070 as nickel-containing cold-reduced stainless not further worked.