Hot-Rolled 409 Stainless Steel Sheet 4.5mm Thick
Ferritic 409 stainless steel for automotive exhaust, hot-rolled to 4.5 mm thickness, width 600 mm+, flat not coiled. HTS 7219.23.00 for hot-rolled stainless in this thickness without further treatments. Cost-effective corrosion-resistant option.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If polished or burnished
Surface polishing explicitly listed as further worked in US notes.
If razor blade steel specs
Very specific narrow stainless for razors uses 7220 per note (d).
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Lower chromium content requires certification; check exhaust classification rulings
• Pitfall: thickness near 4.75 mm limit needs precise gauging
Related Products under HTS 7219.23.00
Hot-Rolled 304 Stainless Steel Plate 3.5mm Thick
Hot-rolled stainless steel plate made from 304 grade alloy, measuring 3.5 mm in thickness and over 600 mm in width, not in coils and not further worked beyond hot-rolling. It falls under HTS 7219.23.00 due to its specific thickness range (3-4.75 mm), stainless steel composition, and lack of additional processing like cold-rolling or coating. Commonly used in industrial fabrication for its corrosion resistance.
Hot-Rolled 316L Stainless Steel Sheet 4mm Thick
Type 316L stainless steel hot-rolled flat product, 4 mm thick, width exceeding 600 mm, supplied not in coils without any further working. Classified in 7219.23.00 for its thickness between 3-4.75 mm and hot-rolled stainless steel characteristics per Chapter 72 notes. Ideal for marine and chemical processing equipment.
Hot-Rolled Duplex 2205 Stainless Steel Plate 3.2mm
Duplex 2205 (UNS S31803) stainless steel hot-rolled plate at 3.2 mm thickness, width 600 mm or more, not coiled or further processed. HTS 7219.23.00 applies to stainless flat-rolled products in this thickness range without additional working like coating or polishing. Used in oil & gas and structural applications for superior strength.
Type 430 Hot-Rolled Stainless Steel Sheet 3.8mm Thick
Ferritic 430 grade stainless steel hot-rolled into sheets of 3.8 mm thickness and minimum 600 mm width, not in coil form. Meets HTS 7219.23.00 criteria for hot-rolled stainless flat products 3-4.75 mm thick without further working. Suitable for automotive trim and appliances.
Hot-Rolled 310 Stainless Steel Plate 4.2mm Thick
High-temperature 310 stainless steel alloy hot-rolled to 4.2 mm thickness, plates wider than 600 mm, not further worked or coiled. Classified under 7219.23.00 for stainless steel flat-rolled products in the 3-4.75 mm range post-hot-rolling only. Applied in furnace parts and heat exchangers.
Hot-Rolled 17-4 PH Stainless Steel Sheet 3.75mm
Precipitation-hardening 17-4 PH stainless steel hot-rolled sheet, 3.75 mm thick, 600+ mm wide, not in coils. HTS 7219.23.00 covers this thickness of hot-rolled stainless flat products without additional processing. Used in aerospace and high-strength applications.