Hot-Rolled Incoloy 800H Plate
A flat-rolled plate of Incoloy 800H, a high-nickel alloy stainless steel containing over 30% nickel, hot-rolled to a thickness exceeding 10 mm and width over 600 mm, not in coils and not further worked. It falls under HTS 7219.21.00.05 due to its high-nickel composition and hot-rolled state without additional processing.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If alloy steel not qualifying as high-nickel stainless
High-nickel alloys not meeting stainless steel definition move to Chapter 72 alloy steel headings.
If thickness of 4.75 mm to 10 mm
Thinner hot-rolled plates in the same high-nickel category fall under different statistical suffixes.
If cold-rolled instead of hot-rolled
Cold-rolled high-nickel stainless plates are classified separately from hot-rolled products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify nickel content exceeding chapter note thresholds for high-nickel alloy classification; provide mill test reports confirming composition and hot-rolled status
• Avoid claims for rust discoloration as no duty reduction applies per chapter notes
Related Products under HTS 7219.21.00.05
Hot-Rolled Hastelloy C-276 Slab
Thick flat-rolled slab of Hastelloy C-276, a nickel-based alloy steel with approximately 57% nickel, produced by hot-rolling to exceed 10 mm thickness and 600 mm width, supplied not in coils. Classified under HTS 7219.21.00.05 for high-nickel alloy stainless steel not further worked than hot-rolled.
Hot-Rolled Inconel 625 Plate
Flat-rolled plate made from Inconel 625 superalloy with over 58% nickel content, hot-rolled to thickness greater than 10 mm and width of 600 mm or more, not coiled and without further working. This product matches HTS 7219.21.00.05 specifications for high-nickel alloy stainless steel.
Hot-Rolled Monel 400 Sheet Stock
Heavy-gauge sheet stock from Monel 400 alloy (67% nickel-copper), hot-rolled not in coils with thickness over 10 mm and width ≥600 mm, remaining not further worked. Falls precisely under HTS 7219.21.00.05 as high-nickel alloy stainless steel plate.
Hot-Rolled Alloy 20 Plate
Flat-rolled plate of Carpenter 20 alloy (high-nickel stainless with ~35% Ni), thickness exceeding 10 mm, width over 600 mm, hot-rolled condition without coils or further processing. Classified in HTS 7219.21.00.05 for its high-nickel alloy steel composition.